9804Vve Parts

I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom oven, and then in the top oven. After doing some research I discovered this was not uncommon, and the fix usually involved replacing the hinges and/or the hinge receptacles. It didn't look like a difficult fix so I ordered four new hinges and four new receptacles, which arrived quickly. I found a video on YouTube that showed how to replace the hinges and it... Read more

• Won't start

Not knowing for sure that the problem was the capacitor, I was reluctant to purchase and replace the part. I went AppliancePartPros.com web site and clicked on the part replacement video.The repair video was short and well illustrated. Before the repair began, the service rep says, " the reason you would replace the capacitor is that after turning the timer on, the machine would just hum." The instruction video was the reason that I purchased the part at AppliancePartPros.com The part was... Read more

I took the cover off the transmission and determined that the only possible knocking had to be coming from the yoke. I ordered a new yoke and all the tub seals needed to put it back together like new. I also ordered a new drive pulley bearing because this bearing is always turning whenever the washer is used. I cleaned all the parts up while I was waiting for the new parts to arrive. I promised my wife I would make it look like new. I installed all the new parts in one day and let the... Read more

One day my wife went to bake something and the bake/broil buttons as well as #3, #9, and oven light ceased to work. Local repair guy came by and wanted to charge $500 to fix it....YEAH RIGHT! Did a little homework and found this website, spoke with knowledgable staff who pointed me in the right direction. Took me all of about 20 minutes to install new control panel..everything works perfect...THANKS! p.s. In doing my research come to find Maytag did little to insulate control panel from oven... Read more

I ordered the brioler pan for my new stove from y'all it was a little small but that's the part number in the book that I got with the stoveyall did a great job fast shipping just what I ordered will by from again thanks Read more

• Won't start

I have a Jenn-Air microwave that didn't turn on and had no lights. It just stopped working completely. I unplugged the unit and had to remove the rear cover using a *security screw kit* that prevents people from opening the rear panel. Once opened, I removed the fuse and testing it with an OHM reader to determine that the fuse went bad. But I also had to determine why the fuse blew and noticed a sticky oily substance under the Capacitor. I used a rubber glove and needle nose pliers to... Read more

Maytag Dishwasher (about 5 years old). Some of the buttons had stopped functioning. Then the Start button began choosing whether or not to work. Eventually it would not start at all. Upon removing the control panel, the first thing I noticed was that the brackets that hold the two lower screws were broken. (So this was the reason that the door was so hard to open from the time it was new.) I trouble shot the thermal fuse, the door-latch switches, and inspected the control board trying to find... Read more

Replaced it with the part I got from you. Read more

VERY EASY TO REPLACED OLD COVER-UNIT NEW COVER-UNIT. Read more

Replaced the clutch and water pump Read more

Be careful not to tighten or twist the small hex nut in the knob cylinder/housing with force. there is a very small plastic set tab that can be broken off easily. how do I know? The orientation of the switch "box" is horizontal instead of vertical. otherwise, this replacement part # works as expected. I couldn't get the switch to attach plate removed, and the switch removed, without removing the entire cooktop and removing the top glass burner cover. Not difficult, but time-consuming. Read more