Nt17l4 Parts

• Fridge runs too long
• Noisy
• Freezer section too warm
• Fridge too warm

After reviewing the 'how to' video on AppliancePartsPros.com, I unplugged the refrigerator and removed the back cover to access the motor. I then unplugged the wiring and removed the bad motor. I cut the clip plug and wired it to the new motor, installed the fan blade from the old motor and re-installed the new motor. After connecting the clip plug and re-installing the back cover, I plugged the refrigerator in and checked the interior about 5 minutes after the repair. Everything has been... Read more

This was actually one of the easiest fixes I’ve done. All that was required was to remove 3 screws to remove the broken part. I used a pair of pliers to remove the moisture sensors from the broken part to the new one. Read more

• Noisy
• Freezer section too warm
• Fridge too warm

Removed back panel in freezer compartment. Held on by four hex head screws. Disconnected wire assembly from panel and then replaced evaporator fan motor on kitchen table. Evaporator fan motor is attached to back side of freezer panel by four hex head screws. Easy repair to do.It took me about 30 minutes to do the repair. Read more

After shopping for a new Whirlpool Thin Twin Stack, Found appliance parts pros online and decided to take it apart to see if repair was a possibility. APPro's online instructions were easy to follow, in a couple hours it was apart, and I placed the order. Reg ground took a week from NY, so the laundry piled up that week. The parts arrived on Monday morrning, by afternoon the machine was running like new! The cause was the belt tensioner pulley had frozen. Replaced it, drum wheels,snap... Read more

Removed the handle with two screws on the inside front and pulled out the custom wood panel. Pulled the compactor out from under cabinet. Tipped it over on back of unit, supporting it with a little foot stool. Unscrewed two lower screws at bottom of unit holding black trim panel (that held wood panel in place) and lower black rubber flap. Removed two screws on lower outside side of unit that held the foot pedal. Slid off black U shaped metal frame from top of compactor towards bottom. Slid on... Read more

Ordered Bake Element, Y04100019 (Whirlpool AP4283614) to replace a broken bake element on my 30-year old Jenn-Air Model S125 Downdraft Slide-in electric range. Received the element very quickly but it had been damaged in shipping. Called AppliancePartsPros to report this and they quickly shipped another element - very easy process. To install the element, I turned off the power to the range, put on rubber gloves (just in case) and removed the two sheet metal crews at the rear of the oven -... Read more

Ordered new Evaporator part and Drier from Appliance Pros. The part arrived earlier than expected and was properly packaged. I had both parts installed by a professional as they required a level of expertise above my capabilities. Works perfectly. Read more

Replaced motor, fan and lock-nut. My repair was on a built in Refrigerator-Freezer so most of the time was spent on pulling out and putting back the unit to get to the area I needed to behind the upper top. Read more

• Fridge too warm

I replaced the defrost timer. It's a 27 year old Montgomery Wards refrigerator and I couldn't find the correct timer anywhere until I contacted AppliancePartsPros. Great service. Read more

• Fridge too warm

Replaced the heater coil and the Thermostat underneath the freezer floor. 1. Unplug the Power, allow the ice build-up to thaw (Use hair-dryer). 2. Remove the heavy duty Plastic Tray (Freezer Floor) very carefully (the left and right side lips of the tray are snapped behind the sides of the freezer frame, un-snap the lips using flat spatula) . Gently pull out the Tray 3 Remove the plastic shroud (cold air diverter) at the back of freezer section (after removing the screw, tuck-up the shroud to... Read more

Replaced the heater coil and the Thermostat underneath the freezer floor. 1. Unplug the Power, allow the ice build-up to thaw (Use hair-dryer). 2. Remove the heavy duty Plastic Tray (Freezer Floor) very carefully (the left and right side lips of the tray are snapped behind the sides of the freezer frame, un-snap the lips using flat spatula) . Gently pull out the Tray 3 Remove the plastic shroud (cold air diverter) at the back of freezer section (after removing the screw, tuck-up the shroud to... Read more

I was just browsing the web for "ice cube trays".......Saw "AppliancePartsPros".....typed in my Fridge model number, and there were my much needed trays........I was so surprised, I was screaming, "I found them, I found them !!".....you would have thought that I just won the lottery, but it was so frustrating for 2 months, of trying to find these trays !!.....THEN you DID actually shipped them IMMEDIately and I had them the NEXT day...I was really, really shocked !!.....such a wonderful... Read more

Removed old. Installed new. Read more