Need Help?
Call
Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.
With the video that was made from appliance pro.Help me out one hundred percent to understand what I was dealing with Read more
Fix a washer that won't start or lock with a new door strike. This latch catch secures your door during cycles. Simple 2-minute DIY repair with a screwdriver.
Just removed the old and put on the new,simple.On this Fridgidare washer you should lift the door as you close it which should make the striker last.. Read more
Washer won't spin or drain? Error code E47? The door lock assembly often causes these issues. This moderately easy repair typically takes 30 minutes.
I ran a diagnostics check on the washing machine and came up with the error code E47 -Board thinks the door PTC circuit is open in spin. The washer thought the door was open and would not finish the spin. I was left with a washer full of very wet clothes. This repair was SO extremely easy. I only needed to uses a pair of needle nose pliers and a screw driver. It took less than 10 minutes, start to finish. Now the new door lock assembly registers correctly and my clothes are completely... Read more
This is a water inlet valve that controls the flow of hot and cold water into the washing machine tub during the fill cycle. It is an electrically operated solenoid valve that opens and closes based on signals from the control board. Replace this valve if your washer is not filling with water, filling slowly, leaking from the back, or continuing to fill when it shouldn't be.
After tracing the water dripping back up through the inside of the washer I found the water dispenser inlet valve was leaking. I watched several videos to make sure I understood what was involved. I contacted a local parts company to get the part. I also searched online for the part. I found that AppliancePartsPros.com had it cheaper. I ordered late in the afternoon and it arrived the next day. It was fairly easy to installed and saved me a minimum of $99 "diagnostic" fee plus whatever the part... Read more
This is the exterior-facing panel of the dryer door with a chrome finish. It provides the visible outer surface of the door and houses the inner door components. Replace this panel if it is dented, scratched, rusted, or if the chrome finish is peeling or damaged.
Removed and replaced parts about 30 minutes of work. No leaks Read more
Secures the door boot seal to prevent leaks in front-load washers. Replace if rusted, broken, or seal is loose. Verify fit with your model number.
Y'all! This video made fixing my washer easy peasy. The service repair man wanted $352! I paid less than $200 for the parts. I also called around and appliance parts pros was by far the cheapest option. The shipping was unbelievably fast. (Faster than my amazon prime!) Read more
Washer won't drain or has standing water? This drain pump actively removes water after each cycle. DIY-friendly repair, typically takes under 20 minutes.
Replaced pump. All components are accessible from the front of the machine. You have to remove two screws in the back that hold on the top cover, then slide the cover back. This will allow access to the screws that hold on the control panel. Remove the control panel (unplug cable), then remove the spring/wire that holds on the door bellows to the front panel (removing and installing that is the most difficult part of the job) and carefully remove the bellows from the front panel. Then remove... Read more
Fix a washer that won't fill, overfills, or shows E35 error code with this water level pressure switch. Moderate DIY repair takes about 1-2 hours.
Water valve not closing all the way. Water keep entering washer even with power cord unplugged. Parts I ordered fit perfect. Ordered on Thursday night , parts there Saturday. Great service and shipping. Thank Read more
Secures the shock absorber to the outer tub in your washer. Replace if the pin is broken, cracked, or missing to restore proper shock mounting.
With more difficulty and frustration than expected but it works fine now. Things learned: 1. Order only 3 replacement pins. One comes with the shocks that you can't be sure you see in the picture. 2. A circuit board in a plastic box mounted to the floor, left rear, must be removed by two screws to be able to get pliers onto the head of the pin more easily. This helps installation too. 3. A 1/2" deep socket pushed onto the retaining tab of the pin stays there while you pull with pliers from the... Read more
Replacement tub to pump drain hose for front-load washers. Connects the drum to the pump for water drainage. Replace if cracked, leaking, or worn.
Seems like a poor design-hose developed a leak from rubbing on the support pad beneath it. Pretty easy fix if you follow one of the instructional videos online as far as how to get the front panel off of the washer. You can't change this part from the rear access panel. My washer and dryer are stacked so it added some time to the job. Read more
Stabilizes the washer tub during spin cycles. Replace worn or broken rear shock absorbers to restore smooth operation and prevent drum contact with cabinet.
Drive belt transfers motor power to drum for tumbling and spinning. Replace when worn, stretched, or broken to restore smooth drum rotation. Verify fit.
Since I hadn't found the Tech Sheet for the washer (which there should be one inside the top cover) I simply thought I'd buy the drive motor (and a new belt, a.k.a "cheap insurance"). Installed the motor once I'd received it from AppliancePartsPros, the washer worked a couple of cycles then gave me the same "SrV CLL" message. I didn't know how to access the error codes on this model but found the info in the Tech Sheet, so I checked it and got an E53 code. Since I'd replaced the motor... Read more
Front shock absorber kit stabilizes the washer tub during spin cycles. Replace worn, loose, or broken dampers to restore smooth operation and stability.
I tore it apart using. YouTube videos to guide me and found the shocks were loose and floppy. I found the shocks in stock here and had them in my hand 2 days later for only $10 shipping! It runs great now! Read more
Secures the inner bellow seal to the tub in front-load washers. Replace if rusted, broken, or causing seal leakage. Tight installation requires patience.
Watched the video a few times for door boot seal replacement. It was a lot of help! The spring is the hardest to replace and I did enlist the help of my wife. Everything went back on great. If you have to replace the front panel (with the buttons) be mindful that the buttons are spring loaded and will come out. I did not lose any and it went back together just fine. A little touch up paint on the washer and it all looks brand new and works great. And the parts came in quicker than... Read more
Screens lint and debris from wash water as it exits the tub. Replace if damaged, missing, or clogged to restore proper draining. Verify fit by model number.
Bad drain pump impeller--installed new pump and filter you guys rock! right parts ,right price, on time! Read more
Inner door panel for front-load washers. Forms the inner structure of the door and supports the lock mechanism. Replace if cracked, broken, or worn.
I ordered the inside and outer panels. They were delivered in 2 days. Ended up being a 15 minute fix. Very quick delivery and items arrived as expected. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.