Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
The Temperature Sensor is an OEM replacement part for GE refrigerators, designed to accurately monitor and relay the temperature inside the refrigerator and freezer compartments to the electronic control board. By detecting the slightest changes in internal temperature, the sensor allows the control board to make real-time adjustments to the cooling system, activating the compressor and fans as needed to maintain optimal conditions for food preservation.
Over time, the temperature sensor can fail due to electrical issues, exposure to moisture, or general wear and tear. A malfunctioning sensor can lead to improper temperature regulation, affecting the efficiency of the refrigerator and the freshness of stored food.
Symptoms of a bad Temperature Sensor include:
This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances.
I unplugged the fridge and took all the food and shelving out of the freezer and then proceeded to take off the bottom sliding drawer rack on both sides off (4 Phillips head screws). Then took off the light bulb cover and then the light bulb. Then the back wall that covers the coils and tubes that the refrigerant runs through ( 2 screws with hex head). After sliding out the back wall I could see that the entire coil area was frosted and iced up. I took a blow dryer and melted all of it over... Read more
The Defrost Thermostat is an OEM replacement part designed for use in GE refrigerators. This component acts as a safety device in the refrigerator's defrost system, preventing the freezer from overheating during the defrost cycle. It works by monitoring the temperature of the evaporator coil and turning off the defrost heater when the coil gets warm enough, thus safeguarding the freezer from getting too hot.
Causes of a bad defrost thermostat can include corrosion, a blown fuse inside the thermostat, or wear and tear over time, which can lead to malfunctioning of the refrigerator's defrost system.
Symptoms of a bad Defrost Thermostat include:
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
The Fan Motor Grommet is an OEM replacement part for GE refrigerators. This small but essential component serves as a seal and insulator around the area where the fan motor shaft protrudes from the appliance body.
Causes of needing to replace the fan motor grommet can include normal wear and tear over time, exposure to extreme temperatures or moisture, or physical damage due to impact or improper installation.
Symptoms of a faulty or missing grommet include:
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore refrigerator models.
It was after 11:00 at night a few nights ago, I couldn't sleep listening to the whining of the fan in the freezer, it was running and making noise sounding like waaoooww, waaaoww. It also sounded like grumbling of a garbage disposal. The refrigerator fan motor was so noisy it was keeping me up all night going on and off running really loud and about to fail. So I was desperate, and called AppliancePartsPros when I couldn't get to sleep near midnight because the fan was so noisy and Bud in... Read more
The Ice Dispenser Bucket Auger is an OEM replacement part for GE refrigerators. This component is responsible for pushing or "augering" the ice cubes from the ice bucket or bin towards the dispenser chute for easy access.
Symptoms of a failing ice dispenser bucket auger include:
Causes of needing to replace the ice dispenser bucket auger can include normal wear over time, damage from impact or foreign objects, or issues with the auger motor that drives its rotation.
This was a little more involved than I originally thought, but after watching the video on the site it wasn't so bad. They walk you through each step verbally and visibly so you can see exactly what to do. Replacing the auger took around 20 minutes, and only that long because the screw holding the ice shield was a bit tough to turn. I just applied gentle pressure and turned slowly until it became loose. The rest was fairly easy, but I did get a small cut from the ice crusher blades. Nothing... Read more
The Vegetable Pan is an OEM part for GE refrigerators. This part serves as a dedicated storage solution for fruits and vegetables within the refrigerator, helping to maintain optimal humidity levels and ensuring that produce stays fresh longer.
Over time, the vegetable pan can experience wear or damage from frequent use, accidental impacts, or overloading. This can lead to cracks, warps, or breaks in the pan, which might affect its ability to properly store produce or fit correctly within the refrigerator.
Symptoms of a bad Vegetable Pan include:
Changed out the valve and cleaned the lines out Read more
The Ice Door Assembly is an OEM part for GE refrigerators. It is integral to the ice dispenser system, controlling access to the ice chute. This component ensures the efficient delivery of ice cubes or crushed ice when activated and seals off the chute when not in use to maintain the freezer's temperature and prevent frost buildup.
Symptoms of a bad Ice Door Assembly include:
Causes of a bad Ice Door Assembly can include mechanical wear from frequent use, failure of the spring mechanism or solenoid that operates the door, or damage to the sealing surfaces that leads to air leaks.
My refrigerator is 13 yrs old and began to build up frost in the ice cube shoot and the water tube began to freeze up over night. The flapper door was not closing completely. I simply removed the control panel by pulling up and out on the bottom edge, the edge is only about 1/8 inch thick, so don't reach in to far. You should be able to feel a small division line between the control panel and the refrigerator. No screw driver was needed to expose the 4 mounting screws of the inner dispenser... Read more
The Ice Dispenser Solenoid is an OEM replacement part for GE refrigerators. It is a crucial component that controls the flow of ice from the ice maker to the dispenser chute.
Symptoms of a bad ice dispenser solenoid include:
Causes of a bad solenoid can include electrical malfunctions, physical obstructions preventing proper operation, or simply wear and tear over time.
The Slide Assembly RH is an OEM replacement part for GE side-by-side refrigerators. As a replaceable sub-assembly, it restores smooth extension of plastic vegetable/multi-purpose slides on the right interior. The slide measures approximately 16 inches.
Symptoms of a bad slide assembly include:
Causes stem from extended use gradually degrading nylon rollers and wear strips through inevitable friction. Exposure to excessive weights above slide limits may also bend or warp steel support rails quicker.
This genuine GE replacement part is also compatible with Hotpoint, RCA, and select Kenmore models.
Although the web ordering process was clear, I needed some "personal contact" via customer service. It took very little time to assure me the the parts were the correct ones and the video was easy to follow. When the parts arrived in 2 business days, it took only 30 mins. to complete the replacement of the slides. The video was a great way to assure there was no wasted time or effort. Read more
This slide rail is an OEM replacement part for GE refrigerators. The slide rail measures 1.25 inches in height, 2 inches in width, and 16 inches in depth. This durable and reliable slide rail ensures smooth and effortless drawer operation.
Causes of failure involve repeated impact stresses absorbing the weight of the heavy door opening and closing potentially thousands of daily times over 10-20 years.
Symptoms of a faulty slide assembly include:
This OEM replacement part is also compatible with Hotpoint and RCA electric ranges as well.
NOTE: For the right-hand side order WR72X240. For the slide bearing order WR1X2048.
The new slides fit perfectly. One thing to mention is that the slide rails come with the slide bearings so you do not need to buy those separate. When I called I was told I needed the bearings so I bought 3 assuming I would be able to salvage the others. Turns out I did not need them. Read more
The Evaporator Fan Motor is an OEM part for GE refrigerators. It circulates air over the evaporator coils, ensuring consistent cooling throughout the refrigerator and freezer compartments. The motor operates 9.75 volts DC. The motor has a 1/8" shaft and a 12" long, 4-wire harness.
You should replace the evaporator fan motor if it becomes faulty due to wear and tear, electrical issues, or physical damage. Over time, the motor bearings can wear out, or the motor itself can fail due to continuous operation.
Symptoms of a bad evaporator fan motor include:
I changed the motherboard - computer and also changed the motor in the freezer, because it was doing a howling sound every time it turned on. The repair technician asked for $500 for a repair and that is on top of the $230 I paid him two days before. I looked up the parts and decided to try myself and it paid off. Great instructional videos. Thanks Read more
The Door Recess Spring is an OEM replacement part for GE side-by-side refrigerators. It sits within the icemaker door frame to control movement and allow smooth closing/opening of the access point.
Causes of a bad icemaker door recess spring include wear and tear of thin metal coils repeatedly compressing over many years of filling cycles. Exposure to humidity intrusions from melting ice accumulates oxidation shortening spring elasticity.
Symptoms of a bad icemaker door recess spring include:
This genuine GE replacement spring is compatible with Hotpoint, RCA and Kenmore models.
The Refrigerator Union Connector is an OEM replacement part for GE refrigerators. It is responsible for connecting the water supply lines from the kitchen plumbing to the refrigerator, allowing water to flow to the ice maker and water dispenser. The plastic connector assists your water dispenser by joining two 5/16 inch x 5/16 inch plastic water lines. Over time, Union Connectors can crack or break under pressure.
Causes of a bad Union Connector include wear and tear from repeated use, exposure to extreme fluctuations or surges in water pressure, or damage from accidental mishandling.
Symptoms of a bad Refrigerator Union Connector include:
We noticed a puddle of water in front of the fridge a couple of months ago-dried the floor up both times and thought someone had dropped ice-or spilled water. A couple of weeks ago there was water dripping through the dropped tile ceiling in the basement. I shut off the water for the water supply to the fridge at the copper pipe in the basement and removed some of the tiles which felt a little damp. It still dripped all day. When my spouse came home he pulled down more of the tiles. It was as... Read more
The Light Switch is an OEM replacement part for GE refrigerators. It controls the interior light, turning it on when the refrigerator door is opened and off when the door is closed. This ensures proper illumination for visibility when accessing the refrigerator's contents.
A malfunctioning light switch can result from wear and tear, electrical issues, or damage caused by repeated use. Over time, the internal mechanism may fail, or the housing can crack, leading to improper operation.
Symptoms of a bad light switch include:
I ordered a new switch from APP and fixed my fridge. However, the video posted for this repair on this site is not applicable to newer refrigerator models. I have a 2015 GE GTE18IHCRSS and had to drop the control housing (#432 in the diagram) to attach the wire/plug assembly to the switch. Only had to remove the front screw with a 1/4" nut driver and that provided enough of a gap for me to plug in the switch. So the correct method to replace the light switch in a newer model refrigerator is as... Read more
The Dairy Door is an OEM part for GE refrigerators. It is designed to fit into the refrigerator door and provide a covered compartment for storing butter, cheese, and other dairy products. This compartment helps to keep these items at a slightly different temperature than the rest of the refrigerator, which can extend their freshness.
Symptoms of a bad Dairy Door include:
Causes of a bad dairy door can include normal wear and tear from frequent opening and closing, accidental damage from loading or unloading items, or material degradation from exposure to the various conditions inside a refrigerator.
Just enter the appliance model and the all the parts are pictured! Really easy! Read more
The Dispenser Lever is an OEM part for GE refrigerators. It is located on the front panel of the refrigerator and is responsible for activating the dispenser mechanism. When pressed, it engages the internal mechanisms to dispense ice or water into a glass or container.
Causes of a faulty dispenser lever can include regular wear and tear, physical damage, or misalignment. These factors can result in issues such as the lever not engaging or sticking, difficulty in dispensing ice or water, or improper alignment with the dispenser mechanisms.
Symptoms of a bad dispenser lever may include:
I had started to order the part from GE at $34.95 + shipping when I did a search and found AppliancePartsPros.com. I was able to get the same part for half of the price of GE. I placed the order and actually to my surprise received the part the very next day. I watched the video provided on-line to see how to replace the part. It took me about 10 minutes and everything is working well. Beats paying a repairman to come out on their schedule and do the same thing at, I am sure, a much higher... Read more
The Refrigerator Bucket and Auger Assembly is an OEM part for GE refrigerators. It is responsible for storing ice and dispensing it through the refrigerator's ice maker. The auger, which is part of this assembly, rotates to push ice forward and dispense it when activated. This assembly ensures a consistent supply of ice and smooth dispensing operation.
Over time, the bucket and auger assembly can become worn or damaged. Causes of a bad bucket and auger assembly can include regular wear and tear, cracks or breaks in the bucket, or malfunctioning auger components. These issues can lead to inefficient ice dispensing or no ice being dispensed at all.
Symptoms of a bad refrigerator bucket and auger assembly include:
I ordered one but it was the wrong one and was too big so I had to send it back. I called the technician told me which one was the right one and I ordered it. It fit perfectly and I received the credit on the 1st one very quickly after they received it. This experience was very pleasant and I would use them again. Read more