Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Ice maker producing broken cubes or leaking? The ice cube tray often cracks over time. Simple DIY repair—remove 2 screws, unplug, and replace. Video guide.
The amount of water being dispensed into the ice cube tray was excessive, causing overflow of the tray. The water then ran into the collection bin and even down the side walls of the freezer creating a huge block of ice in the bin, and ice all over the lower shelves as well. The excessive build up of ice caused the cube tray to crack and also split the little silicone water grommet that connects to the water delivery tube which directs water into the cube tray. Look out for that little tube... Read more
Plastic cover that protects the ice maker temperature sensor. Replaces broken, cracked, or missing covers to secure the sensor wire and foam insulation.
Samsung refrrigerator. it started when the setting was on cubes but was putting out crushed ice. then months later the water refill was running down into the ice bucket causing a massive block of ice in the bucket. look closely at the first two or three cubes in the ice tray after they unload. mine were not dumping and staying in the tray. when the water refill kicked on it would overfill the tray (because of the leftover cubes remaining in the tray) and would run down into the ice bucket... Read more
If your refrigerator won't cool properly or freezes food, the temperature sensor may be faulty. Moderately easy DIY repair with our video guide.
Customers temp sensor and defrost heater went out in his fridge and we replaced both parts bought thru yall and it works great. another satisfied customer. were completely satisfied with your products. we only use yall :) Read more
Fixing frost buildup in your freezer? This defrost thermostat regulates defrost cycles to prevent ice accumulation. Common DIY repair, takes 30-45 minutes.
I found freezer thermal link was open and not closing when cold. Replacement fixed problem. Read more
Refrigerator not cooling or making noise? A failed fan motor stops airflow, causing warm temps and ice buildup. Moderate DIY repair with multimeter testing.
Ordered the two motors plus ordered the fan blades since I was afraid one might break during replacement. Changed out without breaking Freezer and both ice makers now working fine Read more
Illuminates appliance interior. Replace when burned out or dimming. Verify wattage and base type match your model before ordering. Easy DIY fix.
Dropped light panel by removing two screws with socket set. Unplugged two terminals and unclipped the light socket from the base. Then just clipped the new socket onto the base, plugged the connectors onto the terminals and remounted the base. Total job was less than 15 minutes. Read more
Ice maker producing clumped cubes or ice sheets? The temperature sensor bracket ensures proper ice formation. Simple DIY fix with video guide available.
If your refrigerator runs hot, makes squealing noises, or isn't cooling properly, the condenser fan motor may have failed. DIY repair in 15 minutes.
I bought new parts, motor and fan. Replace the old one. Took me no more than 15 minutes to fix it. Read more
Replacement axle pin for refrigerator front caster wheels. Installs through wheel assembly to secure rolling casters. Needed when bent, broken, or worn.
Samsung does not make it easy to replace the casters. The shafts holding the casters are crimped at the ends and had to be cut off with little room for any tools. I had to jack up the fridge and I used a hacksaw blade with a handle to cut through the wheel shafts. I didn't want to use a reciprocating saw. I couldn't find a way to crimp the new shafts so I drilled small holes at the ends and used cotter pins to retain the shafts in place.The rear caster had no room to slide the new one in... Read more
Fix a refrigerator that won't dispense water or ice with this dispenser switch. Requires removing the display cover and disconnecting housing connectors.
I replaced the control board and the microswitch. Read more
Compressor won't start or cycles on and off every few minutes? This overload relay protects against overheating. DIY repair in about 10 minutes.
The compressor was very hot and did not appear to be running. You could here a relay click on and off 15sec cycle. repeating every 2 minutes! Bought a new overload relay too repair, plus a new thermal protection switch because it was cheap. Both parts are actually located on the compressor behind a plastic cover. Found part numbers for parts by searching the compressor number on google! $25 Repair............ Read more
Self-tapping screw for dishwashers, dryers, refrigerators, and washers. Replace missing, stripped, or damaged screws for secure panel and component mounting.
The start button had been tricky to use. You had to push it in just a certain way to get the dryer to start. Eventually it was non-responsive. All other controls worked and there was no error code displayed. The repair was to replace the whole control board which cost around $100. Heavy sigh.. Be sure to keep track of all your screws. BTW it was not the thermal fuse. All the online videos say this is the first thing to look for when the dryer will not start. Be sure to check with the person... Read more
Ensures clean, fresh-tasting water and ice. Replace every 6 months or when flow decreases. Confirm fit with your model number before ordering.
Put the right Samsung filter in the fridge. Read more
Fridge not cooling or freezer icing over? A worn evaporator fan blade restricts airflow causing warm temps. DIY-friendly repair in under an hour.
Replaces broken or missing spring on French door refrigerator left door flapper assembly. Ensures flapper retracts properly when door closes for tight seal.
Removed refrigerator panel, disconnected light and fan power. Removed fan assembly and replaced motor, grommets and fan attachment spring. Unit had adhesive on spring to help hold the spring. Chatted with customer service and clarified that spring and fan would easily pull off motor shaft. Adhesive probably was extra measure used during original build of the fridge. Noise was due to fan rubbing on housing. New fan position set to avoid any rubbing. Read more
Rubber grommet that secures and cushions the evaporator or condenser fan motor in your refrigerator. Replace if cracked, worn, or missing to stop vibration.