Tool Qt Padding Bi - Model Parts

I had previously replaced the pump about 1 year ago. That was not the problem. Still leaked the same way - intermittently, but always in the center of the washer onto the floor. None of the hoses were leaking - no evidence of corrosion or water mineral residue at any of the hose fittings. So, it must have been something else. I studied the parts diagram for the washer tub assembly and concluded the source of the leak almost had to be the outer tub's Centerpost Gasket. It was really the... Read more

My 9-year-old GE washer, in which I replaced the motor two years ago, developed an extremely loud roaring sound during the spin cycle. After reviewing stories here to pinpoint the problem, I replaced the tub bearing, mode shifter, and tub seal. I also installed a new tub nut, split washer, and belt. This repair involves taking the washer apart in order to get at the tub bearing and mode shifter, which are inconveniently located in the very center of the machine. I bagged labeled all the... Read more

First went through the troubleshooting guide on the website and read the various stories and watched the repair videos for replacing the springs and suspension pads. Then before ordering any parts disassembled the machine only to the point of removing the cabinet to see if there were any obvious issues. The springs appeared OK but I couldn't tell of they were fatigued or not and all were in place but the tub suspension pads were definitely worn out. I then put the machine back together and went... Read more

I ordered parts from appliance parts pro at 3:30 on Friday and they were delivered at bout noon on Saturday the next day. Took the machine apart removed the old pads. With the directions in the packages put it back together and the wife ran 5 loads of clothes through it. Works great. Was awesome to get the parts so quick Read more

After ignoring for a couple of years that the bearings were bad on our Whirlpool Cabrio washer and just closing the door to the laundry room, it started slinging grease underneath during the spin cycle. Knowing that the cost to call out a repairman would be close to the cost of a new washer, I decided that it would be a nice Saturday project after reviewing AppliancePartsPros’ repair video. The bearing & tub seal kit and bearing installation tool arrived in two days. I’ve done a lot of... Read more

I have a 14 year old GE washing machine that had been making a lot of noise while running but had eventually just stopped flat. The agitator and spin cycle would not run. I found this site and made excellent use of all the repair videos to study about my issue. I put in my machine model number and I Immediately was able to start honing in on what my problem could be from website advice about popular repair parts, stories others had shared about their similar machine issues and watching videos,... Read more

Replaced bad condenser motor Read more

Replaced filter. Read more

Remove unit, remove about 12 screw holding the top to the unit switch the tops reverse steps and done Read more

After watching the video that Appliance Parts Pros provided. I replace just about all parts that would cause the washing machine to shake and move. Their video on how to replace each part was better than any one I had seen on YouTube. I just want to thank them for providing just great service. Once all parts were replaced I tested it with an empty load it was great. I got behind on my washing and had several loads. The washer does better now then when I first bought it new. The only thing I can... Read more