Parts for Lg LMV1915NVB / ABKELGA: Section 1 Parts

This truss head tapping screw secures panels, brackets, and covers in your appliance. Replacing a missing or damaged fastener restores a snug fit, reduces vibration, and helps keep components properly aligned for reliable performance.

• Provides low-profile holding power; wide truss head helps secure thin panels and trim
• Replaces lost, stripped, or corroded screws at the original mounting points
• Helps eliminate rattling, vibration, or loose handles/covers
• Addresses situations where a screw will not tighten or backs out during use

• Disconnect power; shut off water/gas if applicable before servicing
• Align parts and hand-start threads to avoid cross-threading
• Tighten until snug; do not overtighten to prevent stripping
• If the receiving hole is damaged, for repair before installing the new screw

This door frame assembly replaces a damaged or cracked outer door frame to restore the washer/dryer door's appearance and structural support. It helps secure the door glass and maintain proper door alignment for safe operation. What it does:

• Replaces a broken, cracked, or warped outer door frame to restore form and function
• Supports and secures the door glass/window to prevent rattling or movement
• Helps maintain correct door alignment so the latch and seal engage properly
• Can reduce drafts, leaks, and vibration caused by a damaged frame

• Disconnect power (and water if applicable) before starting any repair
• Handle glass and frame edges carefully; wear gloves and eye protection
• Retain original screws and mounting hardware unless replacement parts are supplied
• Check door seal/gasket and latch engagement when reinstalling to ensure a proper fit

The Door Latch Hook is an OEM replacement part for LG microwaves. Located internally on the door frame, this metal hook secures firmly into the microwave's door latch bracket when closed. As a common wear point, the hook can experience minor warping over many years of use.

Causes of a bad door latch hook include normal wear and tear, loss of tension, or deformation from frequent door opening and closing cycles long-term.

Symptoms of a bad latch hook include:

• Door that does not close fully or completely latch in place  
• Gaps forming in the door seal when shut
• Inability to achieve a tight, solid seal around the perimeter 
• Latch hook failing to grasp the bracket securely

This OEM LG part is also compatible with Sears/Kenmore microwaves. 

This baffle is the drum fin that lifts and tumbles clothing inside the dryer for even movement and improved drying. It replaces a cracked or missing drum baffle to restore normal drum action and reduce fabric snags. What it does:

• Guides and lifts clothes as the drum rotates to promote even tumbling and drying
• Prevents garments from bunching or catching on drum seams
• Helps reduce thumping or scraping noises caused by a loose or broken baffle
• Restores intended airflow patterns affected by damaged interior components

• One drum baffle

• Disconnect power before starting any repair to avoid shock hazard
• Access requires removing the dryer drum or front panel per your model's service instructions
• Inspect mounting posts and fasteners; replace any damaged clips or screws for secure fit

The Door Latch Spring is a genuine OEM part for LG microwaves. As a key component of the microwave, the door latch spring is responsible for providing the tension needed to securely close and latch the microwave door. It works behind the scenes to ensure a tight seal when the door is shut.

Symptoms of a bad door latch spring include:

• The microwave door not closing or latching properly 
• Gaps appearing around the door seal when shut
• Difficulty opening and closing the door

Causes of a bad door latch spring can include wear and tear over time. Exposure to excessive door slamming can also place undue stress on the spring.

This genuine LG OEM  replacement part is also compatible with Sears/Kenmore microwaves.