Parts for Lg LRM1230W / CWHELGA: Section 3 Parts

This is a truss-head tapping screw used to secure trim, panels, and small assemblies on compatible LG appliances. It provides a low-profile, wide-bearing head that helps hold parts flush and resist pull-through. What it does:

• Fastens plastic and sheet-metal components where a self-tapping thread is needed
• Truss head spreads load to prevent damage to soft or thin materials
• Helps secure control panels, brackets, or trim pieces that require a low-profile head
• Common replacement when original mounting screws are missing, stripped, or corroded

• One truss-head tapping screw

• Use the correct screwdriver bit and moderate torque to avoid stripping the screw or workpiece
• Start threading straight and let the screw form threads without forcing at an angle
• Disconnect power and follow appliance-specific service safety procedures before working internally
• Replace any damaged mating threads or clips for a secure fit

Color: brown. Each prong measures about 5 inches from the center.

This synchronous turntable motor rotates the glass tray inside your microwave to help food heat evenly. Replace it to restore smooth, consistent rotation if the tray has stopped turning, stalls intermittently, or makes unusual noises from the base.

• Drives the turntable via the center coupler to rotate the glass tray at a steady speed
• Promotes even exposure to microwave energy for more uniform heating
• Typical failure symptoms: tray won't turn, rotates only intermittently, or emits grinding/buzzing sounds from underneath
• If power reaches the motor but it doesn't run, the internal windings or gear set may be seized

• Disconnect power to the microwave before servicing
• If mounted over a range, remove the unit from the cabinet with assistance
• Access is typically from the bottom panel; note wire positions and shaft orientation before removal
• After installation, briefly test rotation before full reassembly; inspect the coupler and support for wear