Tappan Gasket & Seal

This O-ring is a small rubber sealing gasket that prevents water leaks at a refrigerator water connection. It restores a watertight seal to stop drips and maintain proper water flow to the dispenser/ice system. What it does:

• Creates a watertight seal at a water line or valve connection
• Helps stop visible dripping or slow leaks from fittings
• Maintains proper pressure and flow by preventing bypass around a joint
• Used where a compressible seal is required between two mating parts

• Shut off water supply and disconnect power before servicing
• Replace only with the correct-size O-ring and seat it evenly in the groove
• Inspect mating surfaces for nicks or debris; clean before installing the new O-ring
• Tighten fittings to manufacturer torque recommendations to avoid over-compression

This replacement door gasket creates a tight seal around the refrigerator or freezer door to help maintain consistent temperatures and reduce energy loss. Designed to match the OEM shape and restore proper sealing. What it does:

• Seals the door edge to help keep cold air in and warm air out
• Helps prevent frost buildup and reduces compressor run time when sealing properly
• Can stop drafts and eliminate wet or warm spots on door edges
• Restores the door's original fit when worn, torn, or deformed

• One door gasket

• Designed for a direct replacement; inspect mounting channel and retainer before installing
• Warm the gasket slightly for easier fitting if needed; avoid overheating
• Clean the door frame and remove old adhesive or debris for a proper seal

This refrigerator door gasket creates an airtight seal around the door to help maintain proper temperatures and energy efficiency. It replaces a worn, torn, or deformed seal to reduce cold air loss and cycling. What it does:

• Seals the refrigerator door to prevent cold air leakage and reduce frost buildup
• Helps maintain consistent internal temperatures for food safety
• Reduces compressor run time and saves energy when sealing properly
• Addresses common symptoms like warm spots near the door, visible gaps, or a torn/cracked seal

• One replacement door gasket

• Disconnect power to the appliance before starting any repair
• Clean and dry the door flange thoroughly before installing the new gasket
• Warm and flex the gasket as needed (hands or warm water) to ease installation and ensure full contact around the door
• After installation, close the door and check for gaps; allow 24 hours for the gasket to fully seat

Size: 4 x 5.5 inch.