Thermador Cooktop Parts

This Tinnerman C nut is a spring-steel speed clip that secures sheet-metal panels and components using a mating screw. It provides a captive thread where a tapped hole or weld nut isn't practical, helping restore proper fit and stop rattles. What it does:

• Provides a captive, reusable threaded anchor for self-tapping or machine screws
• Secures trim, access panels and internal brackets to sheet-metal edges or panels
• Stops panel movement and vibration-related noise when the original clip is damaged or missing
• Works where a conventional nut or stud cannot be used due to limited access

• Disconnect power and unplug the appliance before accessing panels or fasteners
• Position the clip over the panel edge or hole, then press or slide until it snaps into place
• Align the mating screw and thread carefully to avoid cross-threading the clip
• Use hand tools or pliers for placement; do not over-torque the screw once installed

This 90° elbow fits fluid/gas lines, providing a compact right-angle connection between a 3/8" male NPT fitting and a 5/16" tubing. It helps route lines neatly and prevent kinks in tight appliance spaces. What it does:

• Creates a sealed right-angle transition from 3/8" male NPT to 5/16" soft or hard tubing
• Used where space requires a compact turn in water, refrigerant, or drainage lines
• Can reduce stress on hoses and tubing that would otherwise bend sharply
• Common replacement when fittings leak, vibrate, or become corroded

• Inspect mating threads and tubing for damage; replace any worn seals or ferrules before installing
• Hand-start threads to avoid cross-threading, then tighten with appropriate wrench — do not overtighten
• Use thread sealant or tape only if specified for the application; follow appliance manufacturer guidance
• Disconnect power and water/gas supply and relieve system pressure where applicable before servicing

Protective cover that shields and conceals the power cord connection on your cooktop. Replace if cracked, broken, or missing to restore a clean appearance.

This gas manifold assembly routes fuel from the range's supply to individual burner valves so burners heat reliably. Replaces a worn or damaged manifold to restore proper gas flow and consistent burner operation. What it does:

• Distributes gas evenly to each cooktop/range burner via the valve ports
• Helps maintain correct burner ignition and consistent flame performance
• Can fail and cause burners not to light, weak flames, or uneven heat
• Works with the appliance's gas valves and regulator to control fuel flow

• Turn off gas supply and electrical power before starting work
• Only install and follow OEM diagram
• Tighten connections to recommended torque and check all fittings for leaks with a soap solution or approved leak detector
• If you smell gas, stop immediately, ventilate the area.

This hot plate is a 1500W single cooking element designed to restore heat to an electric cooktop. It replaces a failed element so burners heat evenly for normal cooking performance. What it does

• Heats cookware using a 1500-watt heating element for typical stovetop cooking
• Replaces a burned-out or non-heating burner to restore a single cooking zone
• Addresses symptoms like no-heat, uneven heating, or burner that won't warm up
• Works with the existing cooktop mounting and wiring when the element is compatible

• One 1500W single hot plate element

• Disconnect power to the appliance before attempting service to avoid shock
• Inspect wiring and connectors for damage; replace any worn parts per OEM guidance
• Handle the element carefully to avoid bending or damaging terminals

This magnet valve controls the flow of gas to a burner on the range, opening or closing in response to electrical signals from the ignition or safety system. It is an electromagnetic component that ensures gas is only released when proper ignition conditions are met. Replace this valve if a burner fails to ignite, shuts off unexpectedly, or if you smell gas when the burner is turned off.