Thermador Cooktop Parts

This is an overflow drip tray designed to catch liquid spills and boil-overs inside the range or oven cavity, preventing them from reaching internal components. It sits beneath the cooking area and collects excess moisture or grease. Replace this tray if it is cracked, warped, corroded, or no longer sitting flat, which could allow liquids to leak onto electrical parts below.

Fix a loud humming or buzzing noise from your wall oven control panel. This low-voltage transformer powers the control board and related circuits.

If your cooktop burner won't heat or heats unevenly, the heating element may need replacement. This part restores proper cooking temperature control.

Griddle cover for electric cooktops and ranges. Replaces cracked, broken, or missing covers. Protects griddle surface when not in use. Handle sold separately.

Protects beneath your range from heat and spills. Replace if cracked, warped, or missing. Installs under cooktop to shield components and simplify cleanup.

Replacement grease tray cover for ranges and cooktops. Covers the grease collection area to contain drips and spills. Needed when original is cracked or missing.

This pressure regulator controls and stabilizes incoming water pressure to the appliance, helping maintain consistent operation and protect internal valves and seals. Fits systems that use a 3/4 inch inlet regulator. What it does:

• Reduces high incoming water pressure to a safe, steady level for the appliance
• Prevents pressure-related leaks, valve chatter, and premature wear on seals
• Helps maintain consistent water flow for reliable cycles and operation
• Commonly replaced when irregular pressure, humming valves, or water leaks occur

• One pressure regulator (3/4 in.)

• Turn off water supply and power to the appliance before starting; relieve system pressure first
• Inspect connection fittings and seals; use appropriate thread sealant if required by the OEM
• Tighten to manufacturer torque recommendations and check for leaks after restoring water

Replace your cooktop drip pan if cracked, rusted, or stained. This pan sits beneath the burner to catch spills and protect the cooktop surface.

Mounting bracket that secures double burner assemblies to your gas cooktop frame. Replace if cracked, bent, or missing to properly support burner units.

This door latch assembly secures the door closed and signals the control that it's safely shut, allowing cycles to start and run. Replacing a worn latch restores a reliable safety interlock and consistent operation.

• Secures the door and engages the safety interlock so the appliance can operate
• Sends a "door closed" signal to the control
• Common symptoms: door won't latch or stay closed; unit won't start or pauses as if the door is open; intermittent operation when the door is bumped; visible wear or damage to the latch
• Helps prevent nuisance "door open" indications

• Disconnect power before servicing
• Access the latch from the door area; remove inner panel or trim as required by your model
• Note wire positions, transfer connectors, and mount the new latch in the same orientation
• Test door closure before reassembly

Secures the griddle igniter electrode in correct position next to the burner. Replace if bracket is broken, bent, or missing to restore proper alignment.

This is a cylindrical sleeve that serves as a trim piece on a range or oven. It fits around a component to provide a finished appearance and a secure connection. Replace this sleeve if it is cracked, warped, or no longer fits snugly, which can cause a loose or rattling feel.

Zinc-plated #8-32 wing nut for ranges, cooktops, and grills. Replaces missing, stripped, or corroded wing nuts on burner assemblies and mounting brackets.