Thermador Dishwasher Switch

• overflowing
• Will not fill with water

I checked continuity at the float switch since I knew the inlet valve was working when direct wired to 120v. Switch did not have continuity. Replaced switch and inlet valve worked at start of cycle. Read more

Initially performed troubleshooting over the phone with Bosch customer support and did preliminary research on the web. Ultimately had to call out service technician to isolate/confirm problem. He confirmed the problem was most likely the switch (if not, the actually computer processor) and gave me the part number (since it was going to take 10 BD's for him to get the part). I ordered through Appliance Parts Pros and received the part in only 2 days. However, upon trying to install it, I... Read more

Using instructions I obtained over the internet, I first removed the DW's bottom cover panels so I could look inside the DW (with a flashlight) while it was running. I had to put their dishwasher through several wash cycles before I could pinpoint the location of the leak. (The water appeared to be coming from above on the left side of the DW, near the top, rear of the DW's blue "Pressure Chamber." Thinking that the problem likely lay in either a malfunctioning Pressure Chamber or in a... Read more

Took door off, saw that dispenser linkage was ok, I could open and close by hand, so figured the wax motor or the wiring to it were most likely the problem. I took off the wax motor ( actuator) and ran 120 volts to it via jumper wires, and it did not move at all, so figured good chance that was the problem. Found part # on your site, received new one quickly from you, put it in and works great. Thanks. Read more

I THOUGHT IT WAS THE DOOR SWITCH BECAUSE WHEN I SLAMMED THE DOOR IT WOULD WAKE UP. I FIGURED OUT HOW TO TAKE IT APART AND FOUND ONE BURNT LOOKING TERMINAL AND SAID JACK POT. ORDERED SWITCH FROM YOUR CO. WHICH CAME AMAZINGLY FAST (ONE DAY!) PUT IT BACK TOGETHER. REPAIR MAN ARRIVING SHORTLY Read more