Thermador Range Heating Element

Restore reliable baking performance with this bake heating element. Mounted at the bottom of the oven, it provides the primary heat source in Bake mode so the cavity reaches and maintains the set temperature for consistent results. What it does:

• Heats the oven in Bake mode to reach and hold the set temperature
• Failure can cause no heat in bake, very slow preheating, or uneven/undercooked results
• Visible cracks, blisters, or a broken coil indicate the element should be replaced
• A shorted element may trip a household breaker or blow a fuse

• One bake heating element

• Disconnect power at the breaker and allow the oven to cool before servicing
• Remove oven racks; take out the element's mounting screws and gently pull the element forward to access wire terminals
• Transfer wires one at a time to the new element; do not allow wires to fall back into the insulation
• Reinstall the element and panels, restore power, and test bake operation

Heating element assembly that restores your appliance's ability to heat water or air so cycles reach the correct operating temperature. Use it to replace a failed heater that prevents proper drying, sanitizing, or heating performance. What it does:

• Heats water or air during operation so wash, sanitize, and dry cycles reach the intended temperature.
• Common repair for no-heat, poor drying, or cycles that fail to reach or maintain temperature.
• Works with the appliance's control and thermal cutoff to deliver regulated heat when called for.
• Replace if the element is visibly damaged, shows an open circuit on a multimeter, or triggers thermal faults.

• Always disconnect power (unplug or switch off breaker) before servicing the appliance.
• Handle carefully; terminals and mounting brackets can be sharp or fragile. Avoid bending element tubing.
• After installation, restore power and run a short diagnostic or cycle to confirm proper heating and no error codes.

This convection heating element replaces the oven's rear/top convection heater to restore even heat circulation and consistent baking results. Designed to match OEM fit and function for compatible Bosch ranges and ovens. What it does:

• Heats oven cavity to enable convection cooking and improved heat distribution
• Restores proper airflow and browning when the original convection element is burnt out or intermittent
• Helps resolve symptoms like uneven cooking, longer cook times, or visible element damage
• Works with the oven's convection fan to maintain set temperatures during bake/convection cycles

• Disconnect power at the breaker before attempting service to avoid shock hazard
• Handle element carefully; avoid bending terminals or damaging insulation
• Basic disassembly of the oven back/upper panel may be required