Thermador Range Parts

Replace your range oven light bulb when it burns out or dims. Restores interior visibility for safe cooking. Verify fit with your model number.

Replace a faulty high temperature cutout fuse if your range won't heat or stops working during use. Direct fit for specific range and oven models.

Used to hold down the jet holder assembly.

This kit includes a simmer control board that regulates low-heat burner operation on the cooktop, allowing precise temperature control at simmer settings. The board manages the cycling of the burner element to maintain consistent low temperatures. Replace this kit if your burners won't maintain a simmer, cycle erratically at low settings, or if the existing control board shows signs of damage or failure.

This is a cooling fan assembly used in wall ovens and ranges to circulate air and prevent overheating of internal components and surrounding cabinetry. It helps dissipate heat from the oven cavity and electronics during and after cooking cycles. Replace this fan if you notice excessive heat on the outer surfaces of the oven, the fan runs noisily or intermittently, or the oven displays overheating error codes.

Captures grease and cooking vapors to keep air fresh and prevent buildup. Replace when clogged or discolored. Verify fit by model number and dimensions.

Oven not heating evenly in convection mode? This rear convection heating element restores proper temperature. DIY-friendly, typically installs in 10-20 minutes.

Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.

This bake element heats the small oven cavity from below during Bake, delivering the radiant heat needed for preheating and consistent baking when the original element fails.

• Provides primary bake heat at the bottom of the small oven cavity
• Works with the oven control to preheat and maintain set temperature
• Common failure symptoms: no or weak bake heat, uneven baking, visible blistering/cracks, or a breaker trip when Bake is selected

• Disconnect power at the breaker before servicing
• Access is typically from inside the cavity; remove mounting screws, pull the element forward, and move wires one at a time
• Support wires so they don't retract into the insulation; avoid bending or stressing the new element
• Restore power and run a bake cycle to verify proper heating

Replacement housing cover for microwaves and ovens. Closes and protects internal openings. Restores secure fit when original is cracked, missing, or warped.

Fixes no spark at burners or oven not lighting issues. This ignition module generates the high-voltage spark needed to ignite gas at electrodes.

This LP main jet regulates propane flow to a surface burner to maintain a clean, stable flame. Replace a clogged or incorrect jet to restore proper burner performance, especially when converting a cooktop or range from natural gas to LP.

• Meters LP gas to the burner head for correct flame size and combustion
• Direct replacement for a damaged, clogged, or incorrect jet during service or LP conversion
• May help with yellow/sooty flames, weak or overly high flames, uneven heating, or delayed ignition

• Shut off gas and power; allow the appliance to cool completely
• Remove grates, caps, and burner head to access the orifice holder
• Start the jet by hand, then tighten gently with the correct tool—do not overtighten
• After installation or any LP conversion, leak-test connections and verify a steady blue flame; other jets and the regulator may also require LP settings per the model's instructions

This gas tap controls the flow of gas to a burner or oven component on a gas range. It regulates the gas supply and ensures proper ignition and flame control. Replace this part if you experience gas flow issues, difficulty igniting a burner, or inconsistent flame output.