Parts for Maytag MDG17CSBGW1: 01 - Top And Console Parts

Pilot light not visible or broken lens? This control panel lens cover protects the indicator bulb and diffuses light. Simple snap-in replacement part.

If your dryer won't start or heat, the relay may have failed. This switch controls electrical current to the motor and heating element.

Dryer won't advance through cycles or stops mid-cycle? The cycle switch controls the timer progression. Moderate DIY repair, 30-45 minutes.

Dryer won't start when you press the button? This push-to-start switch restores one-press starting. Simple repair that reconnects the motor circuit.

This is a 230-volt indicator lamp used in a clothes dryer to signal when a cycle is running or a specific setting is selected. It mounts on the control panel and illuminates to provide visual feedback during operation. Replace this lamp if the indicator light on your dryer control panel no longer lights up even though the dryer is functioning normally.

Replace worn, stripped, or missing 8-18 x 3/8 machine screws that secure control panels, trim pieces, and brackets on your appliance. Restores tight fit.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

Washer won't start or door won't unlock? This lock cam drives the door lock mechanism to secure and release the door for proper cycle operation.

This is a mechanical or electromechanical timer that controls the duration of dryer cycles by advancing through timed and automatic dry settings. It sends electrical signals to the motor, heater, and other components at the appropriate points in the cycle. Replace this timer if your dryer won't start, won't advance through cycles, runs continuously without stopping, or if the timer knob turns but nothing happens.

Case cushion for dryers. Installs on the exterior cabinet to provide vibration dampening. Replace if your cushion is cracked, worn, or missing.

Replace your dryer's top panel if it's cracked, dented, or damaged. This panel covers the top of your dryer cabinet and provides access to components.

This foam seal cushions and seals the icemaker area to reduce vibration and prevent air leaks that can affect ice quality and efficiency. It's a direct-fit replacement designed to restore proper sealing around the icemaker housing. What it does:

• Cushions the icemaker assembly to reduce noise and movement
• Helps seal gaps to limit warm air intrusion that can cause icemaking issues
• Supports consistent ice production by maintaining the intended airflow path
• Resists compression set for reliable sealing over time

• One foam seal for the icemaker housing

• Basic installation; remove power to the appliance before starting
• Align the seal to the icemaker housing, pressing into place until fully seated
• Inspect surrounding surfaces for debris or damage and clean before installing