Parts for Maytag MDG17CSBGW3: 01 - Top And Console Parts

Pilot light not visible or broken lens? This control panel lens cover protects the indicator bulb and diffuses light. Simple snap-in replacement part.

If your dryer won't start or heat, the relay may have failed. This switch controls electrical current to the motor and heating element.

Dryer won't advance through cycles or stops mid-cycle? The cycle switch controls the timer progression. Moderate DIY repair, 30-45 minutes.

Dryer won't start when you press the button? This push-to-start switch restores one-press starting. Simple repair that reconnects the motor circuit.

Dryer light bulb illuminates the drum interior. Replace when bulb burns out or flickers. Confirm fit with your model number before ordering.

Replace worn, stripped, or missing 8-18 x 3/8 machine screws that secure control panels, trim pieces, and brackets on your appliance. Restores tight fit.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

Washer won't start or door won't unlock? This lock cam drives the door lock mechanism to secure and release the door for proper cycle operation.

Dryer won't complete cycles or stops mid-cycle? This timer harness assembly restores power and signal connections between the timer and controls.

Case cushion for dryers. Installs on the exterior cabinet to provide vibration dampening. Replace if your cushion is cracked, worn, or missing.

Replace your dryer's top panel if it's cracked, dented, or damaged. This panel covers the top of your dryer cabinet and provides access to components.

This foam seal cushions and seals the icemaker area to reduce vibration and prevent air leaks that can affect ice quality and efficiency. It's a direct-fit replacement designed to restore proper sealing around the icemaker housing. What it does:

• Cushions the icemaker assembly to reduce noise and movement
• Helps seal gaps to limit warm air intrusion that can cause icemaking issues
• Supports consistent ice production by maintaining the intended airflow path
• Resists compression set for reliable sealing over time

• One foam seal for the icemaker housing

• Basic installation; remove power to the appliance before starting
• Align the seal to the icemaker housing, pressing into place until fully seated
• Inspect surrounding surfaces for debris or damage and clean before installing