Parts for Whirlpool 5KSB555EPK0: 01 - Unit Parts

This painted red housing is an exact-fit outer cabinet component that restores the appliance's exterior finish and protects internal parts from dust and damage. It's ideal for replacing a scratched, dented, or faded housing to improve appearance and protection. What it does:

• Covers and protects internal components from debris and accidental contact
• Restores the appliance's exterior finish and color for a like-new look
• Helps maintain proper airflow and clearances around internal parts
• Useful when original housing is dented, cracked, or cosmetically worn

• Disconnect power (unplug appliance or shut off breaker) before starting any repairs.
• Removal/installation typically requires basic hand tools (screwdrivers, nut drivers) and care to avoid scratching the new finish.
• Handle painted surfaces with clean gloves to prevent fingerprints and scratching.
• If clips or fasteners are reused, inspect for wear and replace as needed.

If your blender buttons aren't responding or speeds won't change, the control panel may need replacement. This repair restores full function.

Seals the motor shaft opening to prevent liquids from entering the housing. Replace if you notice leaks or moisture around the base. Verify fit with your model.

Connects the blender motor to the blade assembly. Replace if stripped, cracked, or worn from overloading or blending hard ingredients without liquid.

This is the cabinet base that supports the appliance lower cabinetry and provides a finished underside. It restores the appliance's stable footing and helps protect internal components from floor-level debris and drafts. What it does:

• Provides structural support for the appliance cabinet and helps maintain proper alignment
• Covers and protects the appliance underside from dust, dirt, and small debris
• Helps reduce draft entry at the appliance bottom and contributes to a finished appearance
• Restores a damaged or missing base to improve stability and safety during use

• One cabinet base

• Disconnect power and water and move the appliance away from the wall before starting
• Use two people for safe positioning and alignment; support the cabinet while fastening
• Reuse existing fasteners when possible; replace damaged hardware with OEM-specified screws
• Follow the appliance service manual for disassembly/reassembly steps and torque guidance

Replacement mounting screw for various appliances. Secures components and panels in place. Needed when original screws are stripped, missing, or lost.

Replacement support foot for blenders. This rubber pad keeps your blender stable and level on the countertop. Replace if cracked, worn, or missing.