Parts for Whirlpool 5KSB1585ROB0: 03 - Unit Parts

Connects the blender motor to the blade assembly. Replace if stripped, cracked, or worn from overloading or blending hard ingredients without liquid.

The Lock Jar is an OEM replacement part for Whirlpool Blenders. Securing the blending jar safely during operation, the lock enables smoothie and food preparation.

Causes of a faulty blender locking jar include normal wear of locking tabs and ridges that hold the jar in place through years of use. Exposure to liquid residue over time may potentially compromise lock performance.

Symptoms of a bad locking jar include:

• Potential tipping or detachment of jar during blending posing spill and injury risks
• Inability to achieve proper suction seal jeopardizing blend consistency
• Lock failure releasing sharp blade assembly with attached jar interior

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.

Seals the motor shaft opening to prevent liquids from entering the housing. Replace if you notice leaks or moisture around the base. Verify fit with your model.

This is a direct-replacement power cord that restores electrical connection so your appliance can receive mains power and operate normally. It fits the factory power inlet and provides a secure connection to your home's outlet. What it does:

• Replaces a damaged or frayed power cord to restore safe power delivery
• Helps stop intermittent power loss, arcing at the plug, or exposed wiring hazards
• Re-establishes a firm connection between appliance and household electrical supply
• Intended for use where the original cord had wear, cuts, or connector damage

• One replacement power cord

• Disconnect appliance from power before installation to avoid shock or injury
• Route and secure the cord per the appliance's wiring diagram and strain-relief location
• Make sure the cord seating and any terminal connections are tight and free of paint or corrosion

Replacement mounting screw for various appliances. Secures components and panels in place. Needed when original screws are stripped, missing, or lost.

Replacement base housing for your blender. Restores the main structural component if the original is cracked, damaged, or broken. Direct fit part.

This is an adjustable leveling foot that threads into the base of the dishwasher to support and stabilize the unit. It allows you to raise or lower each corner so the dishwasher sits level on the floor. Replace this foot if it is cracked, stripped, or missing, which can cause the dishwasher to rock, vibrate excessively, or not align properly with the countertop.

Blender not responding to buttons or speed settings? This control panel restores full function. Direct-fit installation takes about 15 minutes.