Parts for Ge JGBS86SP2SS: Upper Oven Parts

Replacement bumper cushion that protects the range frame where panels meet. Install when the original is worn, cracked, or missing to reduce vibration.

The Sensor Assembly is an OEM component specially designed for GE slide-in electric ranges. It contains both the internal temperature sensor, as well as the electronic board that powers the oven convection fan and thermostat functions. 

Causes of a bad sensor assembly can include faulty solder connections, damaged wiring from overheating, or component failure from years of use.

Symptoms of a bad sensor assembly include:  

• Inability to achieve or regulate proper oven cooking temperatures
• Convection fan failing to operate as programmed 
• Unexplained error codes shown on display
• Oven failing to start baking or convection cooking cycles

As a critical safety and performance mechanism, sensor stability ensures accurate temperature monitoring cycle after cycle. This genuine GE replacement sensor assembly facilitates ideal temperature control and airflow – upholding the quality of cooking your appliance was engineered for. Compatible ranges also include select KitchenAid and Monogram wall oven models.
 

Replace your worn, bent, or warped oven rack. Provides a stable surface for baking sheets and pans inside your range oven. Fits standard ovens.

Replace your gas range oven door gasket to restore proper heat sealing and improve cooking efficiency. Verify fit with your model number before ordering.

This broil element heats the top of the oven to produce high, direct heat for broiling and browning foods. Replaces a damaged or non-heating upper element to restore broil performance and even cooking on the top rack. What it does:

• Generates the high, direct heat needed for broiling and searing
• Heats when the oven is set to the "Broil" function
• Commonly used when the oven won't broil, the top of food isn't browning, or the element shows visible damage
• Works with the oven's broil control and thermostat to reach and maintain broil temperatures

• 1 broil element (upper oven)

• Disconnect power to the range at the breaker or unplug before servicing
• Handle element and terminals carefully to avoid bending or breaking mounting tabs
• Reconnect wiring exactly as found; if terminals are loose or corroded, replace connectors

The Plunger Switch is an OEM part for GE gas ranges. It is an electro-mechanical component that activates the burners and bake/broil modes when the oven door is securely closed.

Causes of failure include worn contact points, damaged wiring, or defective internal components.  

Symptoms of a bad plunger switch include:

• Inability to select oven cooking functions when door is closed
• Error messages related to unsafe door conditions  
• Random activation of burners with door open 
• Failure of door interlock safety feature

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore gas range models. 

Metal angle support bracket that secures interior panels, shelves, or trim inside your range. Replace if cracked, bent, or missing to maintain proper alignment.

Seals between the oven light lens and liner to keep grease and moisture out. Replace if damaged, cracked, or no longer sealing properly.

Mounting bracket secures oven components inside your range. Replace if bracket is bent, cracked, broken, or missing to restore proper structural support.

Uneven cooking or excessive heat outside your oven? This rear cavity insulation restores thermal protection and improves heating efficiency. DIY-friendly.

Rear insulation panel installs behind the oven cavity to contain heat and protect components. Replace if cracked, damaged, or missing to restore insulation.

Shoulder screw for ranges and ovens. Secures internal components and panels. Order a replacement if your original screw is stripped, missing, or damaged.

Replacement oven bottom panel for gas ranges. Covers oven cavity floor. Replace if warped, rusted, cracked, or damaged. Restores smooth baking surface.