Whirlpool Range / Cooktop / Oven Wire, Harness, Power Cord

This wire harness is the appliance's main electrical connector assembly that routes power and signals between components, restoring reliable electrical connections for controls and motors. Use it to replace a damaged, burnt, or broken harness. What it does:

• Carries power and control signals between the appliance's control board, motors, switches, and sensors
• Replaces damaged wiring that can cause intermittent operation, non-responsive controls, or failure to start
• Restores proper connector fit and secure splices to prevent arcing and poor contact
• Helps eliminate issues caused by frayed insulation, broken terminals, or melted wires

• One complete wire harness assembly

• Disconnect the appliance from power (unplug or switch off breaker) before starting any repair
• Compare the new harness to the old one for connector type and routing before disconnecting components
• Route wires along the original paths and secure with existing clips or ties to avoid heat and pinch points

This wire harness routes electrical power and signals between components to restore reliable operation. It replaces a damaged or worn harness to help stop intermittent power, control issues, or components that won't activate. What it does:

• Connects power and control circuits between the control board and major components
• Restores proper electrical continuity when original wiring is frayed, burned, or broken
• Helps resolve intermittent operation, no-power conditions, or unresponsive controls caused by damaged wiring
• Maintains factory routing and connector fit for correct function and safety

• One complete wire harness as shown

• Disconnect all power before starting work to avoid shock or damage
• Verify connectors are fully seated and routed per original path; replace any damaged clips or retainers
• Inspect mating connectors and terminals for corrosion or heat damage; repair both sides if needed

This wire harness connects the appliance's control board to its electrical components, restoring reliable power and signal flow. Replacing a damaged harness helps resolve intermittent operation and restores proper function to affected circuits. What it does

• Transfers power and control signals between the main control and components (motors, switches, heaters)
• Replaces damaged, burned, or corroded wiring that can cause intermittent or no operation
• Commonly used when the appliance won't start, certain functions don't respond, or error codes indicate open/shorted circuits
• Ensures correct connector fit and routing to prevent shorts and improve reliability

• One wire harness

• Disconnect power (unplug or shut off breaker) before starting any repair
• Verify connector orientation and routing before disconnecting old harness; take photos for reference
• Handle connectors gently to avoid bending pins or damaging insulation