Whirlpool Refrigerator Dispenser Parts

Ice maker not filling properly or water leaking in freezer? A cracked fill cup causes inconsistent fills and leaks. Simple DIY fix guides water correctly.

Replaces the lighted paddle you press to dispense water or ice from your refrigerator door. Restores activation when the original pad is cracked, worn, or missing.

This ice door motor drives the dispenser flap that opens for ice dispensing and closes to seal the chute. Replacing a weak or failed motor restores smooth door movement and helps prevent warm air and moisture from entering the freezer. What it does:

• Actuates the ice chute door during dispensing and returns it closed for a proper seal
• Helps reduce frost, condensation, and ice clumping around the dispenser
• Can address ice not dispensing due to the door not opening/closing
• May resolve clicking or grinding noises from the dispenser area

• Unplug the refrigerator before servicing; wear cut-resistant gloves
• Remove dispenser trim/control panel to access the ice door assembly; handle wiring carefully
• Note linkage and wire orientation before removal to ensure proper reassembly
• After installation, test the dispenser to verify the door opens/closes and seals the chute

This small pad fits under a cooktop/range burner grate to cushion and stabilize it, helping prevent wobble and surface scratches. Replacing worn or missing pads keeps the grate level and protects the cooktop finish. What it does:

• Supports and levels the burner grate at its contact points
• Reduces rattling and movement during cooking
• Helps prevent metal-on-metal scraping and scratches on the cooktop
• Replace if pads are missing, flattened, brittle, or the grate rocks

• 1 pad

• Allow the appliance and grates to cool completely; disconnect power/gas if servicing near burners
• Remove the grate; clean old pad residue and thoroughly dry the contact area
• Press the new pad firmly into place; replace all pads on a grate for even height
• Avoid harsh solvents that can damage enamel or stainless finishes

Dispenser facade cracked or discolored? This trim assembly restores your refrigerator's dispenser appearance and proper fit. Straightforward install.

Dispenser funnel guide ice door for side-by-side refrigerators. Guides ice from door dispenser into your glass. Replace if cracked, broken, or damaged.

Collects defrost and condensation water under the freezer drain area. Replace if cracked, warped, or leaking to prevent puddles and water damage.

Drip tray collects defrost and condensation water beneath your refrigerator. Replaces cracked, broken, or missing trays to prevent leaks and floor damage.

Fix leaking or improper detergent dispensing caused by cracks or mineral buildup. This washer dispenser tank restores proper detergent flow.

The icemaker fill cup installs inside the refrigerator icemaker assembly. Replace this part if it's cracked, broken, or missing to restore proper function.

Replacement ice maker fill cup for bottom-mount refrigerators. Directs water into ice mold during fill cycle. Replace if cracked, broken, or missing.

Replace your refrigerator's water dispenser fill cup if it's cracked, broken, or missing. This cup directs water from the dispenser into your glass.