Refrigerator Housing Or Cover

This ice enclosure is the molded housing that surrounds the icemaker inside the freezer, helping position the assembly and guide airflow for reliable ice production. Replace a cracked or missing cover to restore proper fit and protection around the icemaker.

• Mounts around the freezer icemaker to shield and correctly position the assembly
• Helps direct airflow for consistent ice formation and harvest
• Reduces frost intrusion in the icemaker area
• Common fix for cracked, warped, loose, or missing housing

• Disconnect power and turn off the water supply before service
• Remove the ice bin and icemaker as needed to access the enclosure
• Transfer any clips/brackets from the old part and reuse existing hardware
• Verify icemaker alignment and fill tube clearance before restoring power

Replaces cracked, broken, or dented refrigerator cabinet housing. Provides structural support and protects internal components. Restores proper fit.

Houses and protects your refrigerator's electronic control board components. Replace if the housing is cracked, broken, or damaged to restore secure mounting.

Outer housing that holds and protects the refrigerator control assembly. Replace if cracked, broken, or damaged to restore proper mounting and appearance.

Crisper light socket housing base for refrigerators. Installs in crisper drawer area to hold the light socket. Replace if cracked, broken, or missing.

Control box housing cover for side-by-side refrigerators. Protects internal controls and wiring. Replace if cracked, broken, or missing screws.

Directs airflow from the evaporator fan to cooling coils in your refrigerator. Replace if cracked, broken, or missing to restore proper air circulation.

Evaporator fan motor housing for refrigerators. Mounts in the freezer section to enclose the evaporator fan motor. Replace if cracked or broken.

Replace your refrigerator's temperature control housing if it's cracked, broken, or missing. This cover protects the control mechanism inside your fridge.

Control box housing for refrigerators. Mounts at the front top of the fresh food compartment. Replace if cracked, broken, or damaged housing.

Replace your cracked or damaged refrigerator dispenser housing shield. This trim piece surrounds the ice/water dispenser opening, restoring appearance.

This liner sump is the molded drain pan that collects and channels defrost and condensation water inside the freezer/refrigerator cabinet, helping prevent leaks and directing moisture to the drain system. What it does:

• Collects defrost and condensation water from the evaporator area
• Channels water to the cabinet drain to avoid pooling and potential leaks
• Helps keep the freezer/refrigerator interior dry and reduces ice build-up around the evaporator
• Compatible with OEM mounting points and drainage pathways when correctly installed

• One liner sump

• Disconnect power to the appliance before beginning service
• Access may require removing interior panels or the evaporator cover; follow factory service instructions
• Handle carefully to avoid damage to the molded drain passages; ensure proper seating and seal when reinstalling
• After installation, restore power and run a short defrost or water test to ensure proper drainage

White dispenser recess housing for refrigerators. Covers the dispenser opening in the door. Replace if cracked, discolored, or damaged. Direct fit.