Parts for Maytag MSD2737GRW: 02 - Controls Parts

Fixes loose panels, rattling doors, or wobbly components caused by stripped or missing screws. Secures brackets, covers, and mounting hardware. Easy DIY.

Fix a fridge that runs constantly or won't maintain temperature with a new temperature control thermostat. Restores proper cooling cycles in 30 minutes.

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Fridge not cooling or running constantly? A faulty defrost timer causes frost buildup and temperature swings. Most DIYers replace it in 15 minutes.

Replacement oven door gasket that seals the oven cavity to maintain proper cooking temperature and improve energy efficiency. Replace if torn or worn.

Illuminates appliance interior. Replace when burned out or dimming. Verify wattage and base type match your model before ordering. Easy DIY fix.

The Whirlpool EveryDrop Refrigerator Water Filter 7 features a coconut carbon filter that reduces contaminants to provide clean, fresh tasting water. This filter is used Whirlpool side-by-side refrigerators which accept Filter 7. Single filter. Simple, quick turn installation requires no special tools. For best performance, replace every six months. Certified to fit these leading refrigerator brands: Maytag and Jenn-Air. Micron Rating: 0.5. Filter Media: Coconut Carbon Block. Flow Rate: 0.5 GPM. Temp Range: 33 - 100 °F. Pressure Range: 30 - 120 psi. Meets NSF Standard: 42. Approved for WQA Gold Seal. Approximate dimensions: 8.25" x 8.25" x 6.5"

This refrigerator water filter bypass plug is used when you don't want to use a filter. Color: white. It measures about 3 inches in diameter.

This control wire harness routes power and control signals between the appliance control board and components, restoring reliable electrical connections for proper operation. Designed as a direct replacement when the original harness is damaged or faulty. What it does

• Carries power and low-voltage control signals from the main control to switches, sensors, and motors.
• Restores lost or intermittent function caused by frayed, burned, or broken wiring.
• Helps eliminate control errors and communication faults tied to damaged harness connections.
• Maintains correct routing and connector fit to prevent chafing and short circuits.

• One control wire harness as shown

• Always disconnect power (unplug or shut off breaker) before beginning work.
• Compare new harness to the old one to ensure matching connector types and lengths before installation.
• Label or photograph connector locations to ensure correct reattachment; route and secure harness away from heat and moving parts.