Parts for Maytag FAV9800AWW: 03 - Control Panel, Top & Lid Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Valve with thermistor connection.

Specs: 10 - 16 x .375

Screw: 8-16 x 3/8 inch.

Screw: 8-16 x 3/8 inch.

The Switch Mounting Screw is an OEM part compatible with Whirlpool washing machines. This screw securely mounts the cycle selector switch within the control console assembly. Proper fastening ensures dependable operation of control functions.  

Causes of a bad mounting screw can stem from stress cracks developing over multiple years of operation. Vibrations accumulate, slowly loosening connections housed in a wet environment.

Symptoms of a bad mounting screw include:

• Loose or rattling switch within the console face  
• Difficulty selecting cycles as buttons wobble out of place
• Water intrusion hastening corrosion of electrical terminals
• Potential shock hazards if live connections are exposed

This Whirlpool replacement screw restores a tight mounting point. It is compatible with brands like Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This hose clamp secures a rubber or plastic hose to its fitting to maintain a tight, leak-resistant seal. Replace a worn or missing clamp to stop drips and keep appliance water connections secure.

• Fastens a hose to a barb or port to prevent leaks
• Helps keep hoses from slipping off due to vibration or pressure
• Restores proper sealing when a clamp is rusted, bent, or stripped
• Common symptoms: water dripping at a hose joint, loose hose connection, or a clamp that won't tighten

• Disconnect power and shut off the water supply before servicing
• Place a towel to catch residual water when removing hoses
• Position the clamp just behind the hose barb/bead and secure with the appropriate tool
• Restore water and power, then run a quick check for leaks at the connection

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Factory fastener screw secures panels, brackets, and trim inside appliances. Replace missing, stripped, or damaged screws to restore tight fit.

This splash guard prevents water from escaping the washing machine tub during agitation and spin cycles. It replaces worn or damaged guards that allow water to leak into other areas of the machine. Install when you notice water in the motor area, rust on internal components, or leaks during wash cycles.

Size: 5 foot long. Rubber fill hose used on most automatic washing machines. Two hoses used per machine.

This is a rubber gasket that sits inside the water inlet hose connection on your washing machine. It creates a watertight seal between the hose fitting and the water supply valve to prevent leaks. Replace this gasket if you notice water dripping from the hose connections at the back of the washer.

Filters debris and sediment from incoming water before it reaches the inlet valve. Replace if clogged or missing to restore proper fill flow. Confirm fit.

Fix a washer that won't start or stops mid-cycle. This lid lock magnet attaches to the inner lid and signals the machine it's safe to run.

Fix a washer that won't start or spin with this lid lock switch assembly. Direct replacement part restores safety interlock function. Moderate DIY repair.

Fix a washer that won't start or stops mid-cycle. This lid lock magnet attaches to the inner lid and signals the machine it's safe to run.

Replace your washer hinge bushing to restore smooth, quiet lid movement and proper alignment. Fixes squeaky or misaligned lids. Confirm fit with your model.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.