Parts for Dacor EF42BDCBSS: 08 - Ice Bin Parts

Secures control panels, trim, and covers on your dryer. Replace missing, stripped, or corroded screws to restore proper fit and reduce rattling.

Secures control panels, trim, and covers on your dryer. Replace missing, stripped, or corroded screws to restore proper fit and reduce rattling.

Flat plain washer that distributes load and spaces hardware on appliance assemblies. Replace if worn, missing, or needed for secure fastening.

Machine screw secures appliance panels, brackets, and internal components. Replace missing, stripped, or worn fasteners for reliable assembly.

Fixes ice dispenser not dispensing or auger not turning. This motor assembly drives the auger shaft that moves ice from bin to chute. Moderate difficulty.

Ice not dispensing? A worn auger drive bar with stripped threads prevents ice from moving through the chute. Moderate DIY repair with video guidance.

Replacement fastening screw for securing trim, panels, and brackets inside appliances. Use when original screw is missing, stripped, or damaged.

Replacement fastening screw for securing trim, panels, and brackets inside appliances. Use when original screw is missing, stripped, or damaged.

This guide yoke is a replacement guide that supports and guides a moving assembly so the appliance part moves smoothly and stays aligned. Replacing a worn guide yoke restores reliable, quiet operation and reduces binding or misalignment. What it does:

• Guides and stabilizes a sliding or pivoting component to maintain proper alignment
• Helps prevent rubbing, binding, or uneven movement of the associated assembly
• Reduces noise caused by worn or damaged guide surfaces
• Restores smooth operation when the original guide is cracked, bent, or excessively worn

• One (1) guide yoke

• Disconnect power (and gas where applicable) before servicing to prevent shock or injury
• Access the mounting location by removing the relevant panel or assembly
• Install new guide in the same orientation; secure fasteners snugly but do not overtighten
• Test the moving assembly for smooth operation before reassembling panels

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Machine screw secures appliance panels, brackets, and internal components. Replace missing, stripped, or worn fasteners for reliable assembly.

This replacement bottom cover protects the ice maker assembly and channels water/ice properly for reliable operation. It restores proper alignment and helps prevent leaks and ice buildup when the original cover is cracked or missing. What it does:

• Shields the ice maker components from debris and accidental contact
• Guides melted water back to the reservoir to reduce pooling and leaks
• Helps keep ice cubes contained and properly directed into the bin
• Prevents frost or ice buildup that can interfere with the dispenser or icemaking
• Restores proper fit and alignment after damage or wear

• One ice maker bottom cover

• Disconnect power to the appliance before beginning any service
• Remove the ice maker/module per factory instructions to access the cover
• Inspect mounting tabs and surrounding components for damage before installing
• Use only manufacturer-recommended fasteners and replace any broken clips

Fixes loose panels, rattling doors, or wobbly components caused by stripped or missing screws. Secures brackets, covers, and mounting hardware. Easy DIY.