Amana Washer Panel Parts

This Washer Lid is an OEM replacement part for Speed Queen washers. It serves as the main cover and provides access to load and unload clothes during washing and rinsing cycles. The lid must be sealed tightly to minimize noise and ensure optimal energy efficiency.

Causes of a bad lid include long-term exposure to heat and moisture during use, impact or other physical damage.

Symptoms of a bad lid include:

• Excessive noise during spinning or agitation cycles
• Long wash times and higher energy bills due to leaks
• Difficulty opening or closing the lid securely
• Warping or bulging appearance

This OEM Speed Queen part is also compatible with American Dryer Corporation and Continental clothes washers.

The Rear Access Cover is an OEM part for Whirlpool refrigerators. It protects the rear components of the refrigerator, such as the compressor, condenser coils, and electrical connections, ensuring these vital parts are shielded from dust, debris, and potential damage while still allowing for necessary ventilation.

Causes of a bad rear access cover can include wear and tear from prolonged use, accidental impacts that cause cracks or breaks, or damage during maintenance or repairs. 

Symptoms of a bad rear access cover include:

• Cracks or visible damage to the cover
• Difficulty securing the cover in place
• Excessive dust or debris around internal components
• Rattling or noise from a loose cover

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This top panel is the exterior upper cover that protects internal washer parts and gives the appliance a finished look. It restores a secure mounting surface for the control area and helps keep water and debris out of the cabinet. What it does

• Covers and protects internal components at the top of the washer cabinet.
• Provides the mounting surface and alignment for the control console and lid.
• Restores appearance when the original panel is dented, cracked, or rusted.
• Reduces rattles or vibration caused by a loose or warped top.

• Disconnect power and water supply before starting any repair.
• Use basic hand tools; some screws or clips may need to be removed to lift the old panel.
• Handle edges carefully — metal panels can be sharp.
• Have a second person assist if needed to prevent bending or dropping the panel.