Amana Washer Valve

This mixing valve controls and directs hot and cold water into the washer to produce the desired fill temperature for each cycle. Replaces a worn or leaking inlet control to restore correct water selection and filling behavior. What it does:

• Directs hot and cold water to create the set wash or rinse temperature
• Opens and closes water flow during fill cycles so the tub fills to the correct level
• Commonly replaced for leaking, no-fill, or incorrect-temperature symptoms
• Works as the washer's water inlet/mixing control within the water valve assembly

• One mixing valve assembly (single unit as shown)

• Disconnect power and shut off both hot and cold water supplies before servicing
• Handle gently; avoid bending or stressing inlet ports and electrical connectors
• Verify hose and connector condition when reinstalling; tighten fittings to prevent leaks

The Valve is an OEM part for Whirlpool washing machines. It controls the flow of water into the washer tub at designated stages in the washing process. Water enters through the valve inlet and is distributed to internal components like the detergent dispenser, water pipes, and sump hoses. 

Causes of a bad valve can include mineral scale buildup inhibiting proper flow regulation over time, or cracks and leaks from wear and tear on rubber gaskets and seals. 

Symptoms of a bad valve include:

• Slow or incomplete fills during washing cycles  
• Water not dispensing correctly through hoses or dispensers
• External water leaks from the valve area
• Error codes related to water level or pressure issues

This OEM Whirlpool replacement part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Washer Water Inlet Valve is an OEM part for Whirlpool washing machines. This valve controls the flow of water into the washer, opening and closing to allow the correct amount of hot and cold water into the machine during different stages of the wash cycle.

Causes of a bad water inlet valve can include wear and tear over time, sediment build-up, or damage from high water pressure. These issues can cause the valve to malfunction, leading to improper water levels or no water entering the machine at all.

Symptoms of a bad water inlet valve include:

• Washer not filling with water
• Slow fill or no water flow
• Water leaking from the valve area
• Inconsistent water temperature during cycles

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.