Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Water Level Pressure Sensor by Whirlpool

4.89 (64)
By: Whirlpool
Part Number: OEM18025296
Manufacturer Part Number: WP34001324

This sensor is connected to the washer's tub and monitors water levels by detecting air pressure changes in the pressure tube. Replace if the washer overfills, underfills, or displays water level error codes.

More

Questions & Answers

For Whirlpool Washer Water Level Pressure Sensor (Part Number: OEM18025296)

View all Questions

Kim for Model Number Wf393btpawr/a2

Our Samsung front load washer is throwing a 3E code but we don’t think the problem is really related to this code. The washer works until it gets to the last spin cycle. On a quick wash, the pump motor will get stuck on 8 to 9 minutes. It goes back down to 5 and then back up to 8 minutes. The pump sounds like it runs continuously and then gets stuck trying to pump. It spins back and forth a little but won’t go into the high-speed spin to take out the remaining water from the clothes. Most, If not all the water is drained. We’ve replaced the pcb (suggestion of a technician from Samsung), the hall sensor and we have a new pump because the problem burnt out the last one. We’ve checked all the hoses for blockages and below through the water level sensor hose and nothing was blocking it. Could it be the water level sensor? If not, what else could be causing this problem?

Answer

Kim, if the pressure hose has a partial clog, it can trick the sensor DC96-01703B into thinking there is water by not allowing pressure to release during a drain. The water level sensor can also be tested while the unit is turned on (cycle not started) and it should have a reading of 26.4KHz. However, the error 3E can play a role in the issues being experienced. This is going to be a motor or hall sensor error and it is recommended that the motor wire harness DC93-00251Q is inspected for any loose connections. The wires can be tested for continuity to verify they have no damaged sections (in case a wire had become pinched). The rotor and stator assembly would also need to be inspected for any debris. The final check would be inspecting the spin basket for any play by trying to wiggle it inside of the outer tub. The spin basket should not have any play that would allow it to move without the outer tub moving and maintaining equal spacing all around. If the spin basket has play, then it is likely a bearing (rear bearing 6601-000148, front bearing 6601-002637, and seal DC62-00156A) or the spider shaft DC97-17004E is starting to fail and creating drag.

Read More...

Answered by AppliancePartsPros.com   |   Wednesday, April 8, 2020

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro

Share your thoughts with other customers

Answer or comment
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google