Parts for Hot Point RB790SR2SA: 01 - Control Panel & Cooktop Parts

Complete cooktop glass assembly for electric ranges. Replaces cracked, shattered, or worn glass cooking surface. Includes mounting hardware for installation.

Burner won't adjust temperature or stuck on high? This surface burner control switch restores heat control. Quick 10-minute fix with basic tools.

Burner won't shut off or stays on high? The infinite control switch regulates surface burner heat. Easy DIY repair, typically 10-15 minutes to replace.

Indicator light that illuminates when burners or oven are active. Replace if it stays on constantly or fails to light. Verify fit with your model number.

Fixes burner stuck on, no low heat, or burner not heating. Controls temperature levels on electric range surface burners. Moderate DIY repair.

Burner won't heat or heats unevenly? This 6-inch radiant element restores proper heating to your electric range cooktop. Plugs into terminal block.

Burner not heating? This 8-inch haliant element often fails when ribbon elements burn out. Requires lifting cooktop to access and replace.

Burner won't heat or only inner ring works? This dual radiant element restores both heating zones on your cooktop. Moderate DIY with basic tools.

Fix a loose or wobbly cooktop element with this radiant element bracket. Secures heating elements to your range surface for stable, even cooking.

Secures the radiant cooktop element in proper position. Replace if bracket is bent, broken, or missing to restore safe element support and alignment.

This control bracket secures the appliance control assembly to the front panel so knobs and electronics stay properly aligned and stable. It replaces damaged or bent mounting brackets to restore a tight, rattle-free control area. What it does:

• Mounts and stabilizes the control console or electronic control module
• Keeps knobs, switches, and display aligned for reliable operation
• Prevents vibration-related noise and movement of the control panel
• Helps maintain proper spacing to avoid contact with internal components

• Disconnect power (unplug or shut off breaker) before starting any work
• Remove the control panel or trim to access the bracket; keep screws and fasteners for reuse unless replacements are supplied
• Handle sharp metal edges carefully and wear gloves and eye protection

This trim control is the molded front trim piece that surrounds and protects the appliance control area, restoring a clean finished appearance and helping prevent damage to the control assembly. What it does:

• Covers the control panel perimeter to hide gaps and mounting hardware
• Protects buttons, knobs, and the control board from spills and debris
• Restores factory appearance when original trim is cracked, faded, or missing
• Fits where exterior control trim has been damaged or worn

• Remove power to the appliance before starting any repair
• Typically installs with screws or clips around the control opening; retain all fasteners
• Handle gently to avoid cracking the trim or scratching the finish

Secures components to your appliance chassis for a rattle-free fit. Replace missing, stripped, or corroded screws to keep panels and brackets aligned.

Replacement oven door hinge for gas and electric ranges. Secures and supports the oven door for smooth opening and closing. Needed when hinge is bent, broken, or door sags. Direct fit replacement part.

Fix F2 error codes, dead oven display, or overheating issues. This oven control board manages temperature and cooking modes. DIY-friendly repair.

Covers the control panel lamp opening to diffuse light and protect from debris. Replace if broken, cracked, or missing to restore clear indicator visibility.

Silicon controlled rectifier for cooktop power control. Includes 8-32 mounting screw. Replace if damaged, corroded, or missing to restore proper installation.

Specially formulated cleaner for ceramic glass and smooth cooktops. Removes cooked-on food, grease, and spills without scratching. Verify fit by model.