Parts for Frigidaire GDG436REW1: 04 - Control Panel Parts

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

Secures panels, brackets, and trim on appliances. Replace when missing, stripped, or damaged to restore a tight, rattle-free fit and proper alignment.

This wire harness connects the range or oven gas valve to the control and safety circuit, ensuring proper signal and power routing for gas ignition and shutoff. It replaces a damaged or worn harness to restore reliable operation. What it does

• Routes electrical signals between the control board and the gas valve so the burner can ignite.
• Replaces frayed, burnt, or corroded wiring that can cause intermittent ignition or no heat.
• Helps restore normal operation when diagnostic tests show open or damaged harness conductors.
• Fits behind the oven or range chassis where the gas valve and control are located.

• One complete wire harness as shown.

• Safety first: disconnect power and turn off the gas supply before starting any repair.
• Verify the harness matches connector types and lengths in your appliance before installation.
• Inspect mating connectors and terminals for heat damage; replace if necessary.

Replace your dryer's broken or missing start knob. This control dial installs on the front panel to restore operation of the start cycle function.

Pan head mounting screw for dryers. Secures internal components and panels. Replace if stripped, missing, or damaged during appliance maintenance.

This is a replacement pan-head, locking screw used to secure the top bracket on compatible Frigidaire appliances. It provides a reliable fastener that helps keep the top bracket and panels held firmly in place. What it does:

• Secures the top bracket to the cabinet or chassis to prevent bracket movement or rattling
• Restores proper alignment of top panels and trim that may be loose or sagging
• Uses a locking feature to resist loosening from vibration
• Pan head design provides a low-profile, finished appearance once installed

• One screw as shown

• Use the matching #8-32 driver or bit and tighten until snug; avoid over-torquing to prevent stripping
• Turn off power and remove panels as needed before accessing the bracket area
• Replace only with the same size and thread type to ensure secure fit
• Replace all related screws for even support

This replacement control panel bezel restores the front trim around a range or oven control area, providing a finished look and protecting underlying controls from spills and wear. It matches black trim with white printed markings for a clean, readable appearance. What it does:

• Covers and protects the control area and underlying components from spills, dust, and everyday wear.
• Restores damaged, faded, or cracked front trim so controls are clearly labeled and accessible.
• Helps keep control buttons and switches aligned and secure behind the trim.
• Improves the appliance's appearance when the original bezel is scratched or discolored.

• One control panel bezel (black with white print)

• Disconnect power to the appliance before starting any repair to avoid shock or injury.
• Typically installs with a few screws or clips after removing the outer trim; handle gently to avoid cracking the plastic.
• Use appropriate screwdrivers and keep fasteners secure; do not overtighten.