Parts for Ge EWA5600K1WW: 01 - Controls & Backsplash Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Replacement end cap for washer left-side assembly. Secures cabinet alignment and protects internal components. Needed when original is cracked or missing.

Right-side cabinet end cap for washers. Replaces cracked, broken, or missing trim piece. Restores proper fit and protects internal components.

Fix washer overfilling or underfilling issues with a new pressure switch. Controls water levels by sensing tub pressure. Moderate DIY repair.

This backsplash assembly is the rear vertical trim panel that finishes the back of a range or stove, protecting the wall and covering control openings for a clean appearance. It restores the oven's original rear fit and look. What it does:

• Covers the rear area of the range to protect the wall from splashes, spills and heat.
• Provides a finished appearance by concealing control openings and wiring access points.
• Helps maintain proper positioning of rear-mounted components that attach to the oven body.
• Useful when the original backsplash is dented, scratched or bent and needs replacement.

• One backsplash assembly as shown

• Disconnect power to the appliance before beginning any work.
• Installation typically requires removing the cooktop or rear screws; keep fasteners for reuse or replace if damaged.
• Use proper lift/handling to avoid scratching the finish; two people may be needed for safe alignment.
• Verify model fit and part number before installation; do not force parts into place.

Replace your washer's control panel button if it's cracked, broken, or missing. This snap-in component installs on the control panel face plate.

Replaces a worn, cracked, or missing washer control knob. Snaps onto the control shaft to restore temperature or function selection capability.

Power line filter sits between household AC and washer's internal wiring. Replace when cracked, corroded, or causing breaker trips due to electrical noise.

Fixes washers that won't start, agitate, or spin. This control board manages cycles and user interface. DIY repair typically takes under 1 hour.

Size: 8-18 b.

Stainless steel hex washer head screw for securing appliance panels, brackets, and trim. Replace missing, stripped, or corroded fasteners during repair.

Plastic housing that secures the drain solenoid to the pump assembly. Replace if cracked, broken, or missing to properly position the solenoid mechanism.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Connects dishwasher wiring to the water inlet valve. Replace if the plug is burnt, brittle, loose, or corroded to restore a secure electrical connection.

Harness to corset & shifter

8-18 hi/lo 5/8

Secures washer hoses at pump, tub, and valve connections to prevent leaks and hose blow-offs. Replace worn or missing clamps for a tight seal. Confirm fit.

If your washer won't fill, overfills, or leaks when off, the water inlet valve may be faulty. Simple 10-20 minute DIY repair with basic tools.

12-pack of inlet hose washers for washers and washer dryer combos. Replace cracked, worn, or missing washers to prevent leaks at water connections.

Replacement water fill hoses for washing machines. Connect home water supply to washer. Replace when cracked, leaking, or showing rubber wear or corrosion.

Connects the pressure switch to the tub in top-load washers. Replace if cracked, punctured, or brittle to restore proper water level monitoring.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.