Parts for Kenmore 363.61542211 (36361542211, 363 61542211): Controls Parts

Size: 8 - 18 ab.

This is a replacement 8-32 trilobular hex screw used to fasten appliance panels and components. It restores secure mounting and helps eliminate loose parts or rattling caused by missing or worn fasteners. What it does:

• Secures panels, brackets, or components in place using an 8-32 trilobular thread form
• Helps prevent vibration, rattling, and loose connections when fasteners are missing or stripped
• Designed to match OEM thread style for proper engagement and retention
• Used wherever a small hex-head machine screw is required for assembly

• Use the correct driver/socket to avoid rounding the hex head
• Tighten to snug fit; avoid over-torquing which can strip threads or damage parts
• If replacing a stripped hole, inspect mating threads and consider a thread repair or alternate fastening method
• Disconnect power to the appliance before accessing internal components to reduce risk of shock or injury

Won't start, spin light blinking, or won't stop spinning? This control board manages cycles and settings. Common DIY repair, typically installed in minutes.

Dryer won't power on or trips breaker? Replace the terminal block and ground strap assembly to restore safe electrical connections. Easy DIY repair.

Replacement strain relief bracket that secures the power cord at entry point. Needed when bracket is cracked, broken, or missing to restore safe cord routing.

Size: 8-32 t. Includes 12 screws.

Protective cover for the fuse and terminal block in your laundry center. Replace if cracked, broken, or missing to shield electrical connections.

Dryer not heating or shutting off unexpectedly? A faulty fuse holder can disrupt circuit protection. This bracket secures your thermal fuse connection.

Fix a washer that won't fill properly, overfills, or stops mid-cycle. This pressure switch restores proper water level detection. Simple 10-minute repair.

Mounting bracket that secures the pressure switch in your washer dryer combo. Replace if bracket is cracked, bent, or broken causing switch misalignment.

Pressure sensor wire harness for washer dryer combos. Connects the pressure switch to control system. Replace if wires are damaged, frayed, or corroded.

Wire harness extension assembly for laundry centers. Replaces damaged, frayed, or broken wiring harness extensions. Essential for safe electrical connections.

Includes 12 screws. Size: 8-18 ab.

Replacement mounting screw for dryer panels, brackets, and components. Needed when screws are missing, stripped, or damaged during repairs or disassembly.