Parts for Kitchenaid KECD867XSS01: 01 - Cooktop Parts

Warming element not heating? This low-watt surface element restores gentle heat to keep food at serving temperature. Simple DIY repair in under 30 minutes.

Burner won't heat or stays on high? This dual radiant surface element restores proper heating. DIY-friendly repair—lift cooktop, disconnect wires.

If your cooktop burner won't heat or only partially heats, this radiant surface element restores consistent heating. Most DIYers complete in 45-60 minutes.

This is a 1200-watt, 6-inch radiant heating element designed for a glass-top electric range. It sits beneath the cooktop glass and radiates heat upward to the cooking surface when activated. Replace this element if the burner does not heat, heats unevenly, or fails to reach the correct temperature despite the control being set properly.

Fixes a loose or sagging oven heating element. This support bracket secures your bake element in proper position for safe, even heating. Easy install.

Push-on control knob for cooktop front panel. Replaces worn, cracked, or missing knobs. Restores appearance and allows reliable control adjustment.

Replaces worn, cracked, or missing flush-style control knob on your cooktop. Restores reliable setting selection and improves control interface feel.

Burner not heating or stuck on one temperature? This infinite switch restores variable heat control to your cooktop. Moderate repair difficulty.

Fixes dual burner stuck on high, won't heat, or no inner ring control. This infinite switch restores precise temperature selection. 45-60 minute DIY repair.

If your cooktop burner won't heat or lacks temperature control, a faulty dual infinite switch is often the cause. Restores precise heat settings.

Burner won't turn off or only heats on high? This infinite switch controls heat settings for your electric range's surface element. DIY repair.

This blower speed switch lets you select the blower/fan speed to restore proper airflow control in your appliance. It replaces a worn or faulty speed selector so the blower will respond correctly when you change settings. What it does:

• Controls the blower/fan speed so the appliance can run at selectable airflow levels
• Replaces a switch that is stuck, unresponsive, or only running at one speed
• Restores reliable electrical connection between the control circuit and blower motor
• Helps eliminate intermittent fan operation or loss of speed selection

• Disconnect power to the appliance before starting any repair.
• Verify wiring placement and retain original fasteners; wiring diagram for correct connections.
• Handle terminals carefully to avoid bending or damaging contacts.

This is an air grille that covers the downdraft vent opening on a cooktop or range. It allows air to flow into the downdraft ventilation system while providing a finished appearance on the cooktop surface. Replace this grille if it is cracked, warped, discolored, or if the vent slats are broken and restricting proper airflow.

Black rubber grommet that fits around cooktop control knobs. Prevents debris from entering the control panel. Replace if cracked, missing, or worn.

Replacement trim piece that restores the finished edge around your cooktop. Covers gaps between cooktop and countertop. Replaces worn, dented, or bent trim.