Parts for Thermador C302US: Cover Parts

A 1/2 in. 90° connector used to join the appliance water inlet to the household supply, restoring a secure right-angle connection and helping prevent kinks or strain at the hose junction. What it does:

• Creates a sealed right-angle connection between the appliance water inlet and supply line
• Restores proper water flow when the previous connector is damaged or leaking
• Reduces strain and hose kinking at the inlet fitting
• Commonly replaced to stop visible leaks or water drips at the connection

• Turn off the water supply and disconnect power to the appliance before installing
• Use appropriate thread sealant or tape where required by the appliance manufacturer
• Hand-start threads to avoid cross-threading; tighten with a wrench until snug — do not overtighten

This part has been discontinued by the manufacturer and is no longer available.

Broil griddle pan assembly for ranges and ovens. Includes slotted cover and pan. Replace your cracked, warped, or missing broiler griddle components.

Flexible conduit cable that protects electrical wiring in your oven. Replaces cracked, damaged, or worn conduit. Installs between junction box and unit.

This part has been discontinued by the manufacturer and is no longer available.

This is a replacement wiring diagram (schematic) used to identify electrical connections and component locations for service and troubleshooting. Keeps wiring information on-hand so technicians can follow the correct circuitry during repairs. What it does

• Shows the appliance's electrical wiring layout and schematic symbols for components and connectors
• Helps locate wire colors, connector pinouts and circuit paths for diagnostics
• Useful when verifying continuity, tracing faults, or replacing control components
• Replaces missing, damaged, or illegible schematics that hinder safe, accurate repairs

• Disconnect power to the appliance before accessing electrical components or using the diagram to guide repairs
• Keep the diagram dry and free of grease; store near the appliance or with service documentation
• Use the schematic alongside official service manuals and wiring harness diagrams for complete guidance

Phillips pan head mounting screw for cooktops and ranges. Replace this zinc-coated fastener if lost, stripped, or corroded during appliance repair.

Wire harness for wall oven lower door latch assembly. Connects latch mechanism to control system. Replace if wires are damaged, frayed, or connectors broken.

Fix a blank or flickering oven display with this display signal harness. Connects the control board to the display panel. Moderate DIY repair.

Communication signal wire harness for wall ovens and ranges. Connects control boards to transmit data signals. Replace if wires are frayed or damaged.

Wire harness that connects to your wall oven's door latch assembly. Replace if the harness is damaged, wires are frayed, or connectors are broken.

This meat probe sensor is a temperature-sensing device that inserts into food while it cooks in the oven, allowing the oven to monitor the internal temperature and automatically stop cooking when the target temperature is reached. It connects to a jack inside the oven cavity via a heat-resistant cable. Replace this probe if your oven no longer reads the food temperature accurately, displays a probe error code, or if the cable or tip is visibly damaged.