Crosley Chassis Or Cabinet

The Oven Bottom Panel is an OEM component for Frigidaire oven models. Located on the base of the oven interior, this metal panel provides structure and support. 

Causes of a bad oven bottom panel include warping or damage due to exposure to high heat over time. Small nicks or cuts could allow heat to escape and reduce the oven's efficiency. Intentional or accidental impact during cleaning can also weaken the material.

Symptoms of a bad oven bottom panel include:

• Uneven or inefficient heat distribution within the oven
• Visible warping or damage to the panel surface
• Reduced heat retention leading to longer cook times
• Potential safety hazards if the metal is weakened

This OEM Frigidaire part is also compatible with some Kenmore models. 

Color: White

Includes gasket sealer.

This outer cabinet assembly replaces the dryer's main outer shell to restore structural support and proper alignment of the drum and controls. It protects internal components and helps reduce vibration and rubbing for safer, quieter operation. What it does:

• Houses and supports the drum, motor, blower and control components
• Keeps internal parts aligned to prevent rubbing, noise or binding
• Protects electrical and gas components from debris and accidental contact
• Helps maintain proper airflow path by securing panels and seals
• Restores proper fit after dents, corrosion, or impact damage

• Disconnect electrical power (and gas supply for gas dryers) before starting any work
• Removing the top and front panels and drum may be required for access
• Handle large panels carefully; two people may be needed to avoid injury or damage
• Inspect door seals, mounting hardware and gaskets and replace if damaged

This burner box is the oven's metal housing that holds and positions the bake/broil burners and channels gas flames for proper heating. Replacing a damaged box restores safe flame direction and consistent oven operation. What it does

• Supports and secures the bake and broil burners inside the oven cavity
• Directs burner flames and helps ensure even heat distribution
• Helps prevent flame impingement on surrounding components
• Commonly replaced for visible corrosion, warping, or blistered metal that affects flame pattern

• One burner box (oven burner housing) as shown

• Turn off and disconnect power and gas supply before starting work
• Follow OEM service manual for removal and reinstallation steps; handle gaskets and mounting screws carefully
• After installation, check for proper burner alignment and test for gas leaks with a soap solution