1) Unscrewed the metal pieces behind the switch panel. You'll notice 3 screws. Afterwards, I realized that I just needed to remove the screws to the left and right of the switch box. The box then slides out. If you take out the third that connects the box to the wire cover, just remember to screw that back in before you replace the box.
2) To make sure I didn't place the wiring in the wrong place, I basically took the wiring out one by one and placing it into the new switch.
3) Place the new switches in the holes.
4) Place the new switch panel over the switches.
5) Tighten the hex nut over the new switches.
6) Place the new knobs.
7) Put the back cover back in place and screw in the 2 screws on the left and right side.