Electrolux Dryer Hinge Parts

The Door Hinge is an OEM part for Frigidaire dryers. This hinge allows it to open and close properly while maintaining a secure seal during the drying cycle.

Causes of a bad door hinge can include wear and tear from regular use, rust or corrosion due to exposure to moisture, or damage from accidental impacts. 

Symptoms of a bad door hinge include:

• Difficulty opening or closing the dryer door
• The door not sealing properly, leading to heat loss
• Squeaking or creaking noises when moving the door
• Visible damage or rust on the hinge

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This hinge secures the door to the cabinet and provides a smooth pivot. Replacing a bent or worn hinge restores proper alignment and reliable latching so the door opens easily and closes securely.

• Provides the pivot point for the door to open and close
• Supports door weight and keeps it aligned with the latch/strike
• Wear or damage can cause sagging, rubbing, or squeaking
• A misaligned door may not engage the door switch, preventing the cycle from starting

• Disconnect power before servicing; shut off gas supply
• Support the door before removing mounting screws to avoid strain or damage
• Note hinge orientation; transfer any spacers/shims and reuse existing hardware
• Align the hinge, snug screws, then tighten fully and test door operation

This hinge secures and lets a refrigerator door pivot smoothly, restoring proper door alignment and sealing for consistent cooling. Replace a worn or bent hinge to fix sagging doors and uneven gaps that stop the door from closing correctly. What it does

• Provides the pivot point that lets the refrigerator door open and close
• Restores proper door alignment and a tight seal to help maintain interior temperature
• Stops sagging or tilted doors that catch or don't latch fully
• Replaces damaged, bent, or worn hinge hardware that causes noisy or uneven movement

• Disconnect power and empty the door before starting to reduce weight and risk of tipping
• Support the door during removal and installation to prevent damage or personal injury
• Use correct fasteners and torque to factory specification; do not overtighten
• Check striker/closer components and gasket condition