Parts for Kitchenaid KSSP48QMS03: 03 - Freezer Shelf Parts

The Whirlpool EveryDrop Refrigerator Water Filter 5 is an OEM replacement filter for Whirlpool refrigerators. This filter is used in Whirlpool bottom freezer and side-by-side refrigerators which accept Filter 5. 

• Single Port Filter
• Simple turn installation requires no special tools
• For best performance, replace every six months 
• Micron Rating: 0.5
• Filter Media: Coconut Carbon Block 
• Flow Rate: 0.5 GPM 
• Capacity: 300 gallons
• Temp Range: 33 - 100 °F 
• Pressure Range: 30 - 120 psi
• Approximate dimensions: 2.30 x 3.00 x 11.60 Inches
• Meets NSF Standard: 42
• Approved for WQA Gold Seal
• Reduces 16 contaminants, including lead, mercury, asbestos, etc

This basket front replaces the plastic panel on the front of a freezer wire basket. It restores a solid barrier so food stays contained and helps the basket slide in and out smoothly.

• Attaches to the front of the freezer wire basket to create a secure face
• Helps prevent items from falling out of the basket
• Replaces cracked, warped, or missing fronts
• Can improve basket handling and alignment when opening/closing

• Unplug the refrigerator before servicing
• Remove the basket from the freezer and place on a flat surface
• Release the damaged front and align the new front with the basket wires; press until fully seated
• Reinstall the basket and verify smooth operation

Right hand side

Left hand side

This machine screw secures components in place to maintain proper alignment and stability during appliance operation. Replacing a worn or missing screw restores a tight fit and helps prevent vibration, noise, or loosening parts.

• Provides a secure mechanical fasten for panels, brackets, or internal assemblies
• Helps correct rattling, vibration, or loose-fitting parts
• Useful when an original screw is stripped, corroded, or lost
• Sized to match 8-18 thread applications in compatible units

• Disconnect power and shut off water or gas before servicing
• Note original screw location and orientation for correct reassembly
• Start threads by hand to avoid cross-threading; do not overtighten
• Replace any damaged clips or mounts the screw engages