Frigidaire Cooktop Parts

New timer! Read more

Tappen Gas Stove circa 1981 (uses Fridgidaire parts). Unplugged stove from 110 wall outlet. Spark control module located on back side of stove about mid-way down on left side under a black cover that juts out. Black cover had 2 phillips head screws...removed the black cover and the spark module was right there...held on by 2 additional phillips screws. Sprark module purchased was identical to old one on the stove. Removed each wire, one at a time from the old spark module (slide off) and placed... Read more

Watched YouTube to see how. Spade electrode connectors are hard to unfasten. Used flat bladed screwdriver. Used heavy gloves to reconnect them. Must mark all connection points with sharpie or have genius memory. Read more

Replaced door hinges Read more

The constant cooking and age of the appliance I repaired corroded the housing attachment that holds the igniter in place to the burner. Also the screws that hold the burner in place to the stove cover were also corroded which caused the burner itself to not stay in place but fall into the stove. By using a screw driver, lift up on the sides of the stove cover to pop the clips that hold it in place. Use a block of wood to hold up the stove cover. On the model I worked on, the igniter removes... Read more

Ordered parts from your website and simply replace covers Read more

Disconnected the power, removed back cover, removed old part and installed new one. I took a picture of the old part and wiring before disassembly. Easy repair, it's the second time the ECU has gone bad. Read more

Removed and replaced Read more

Replaced the cover took care of the sparking and replaced the motor to fix the plate not turning. Read more

Ordered the replacement knob, which I had been unable to find anywhere. They had it and the tool which compares the part with the model # of the appliance was great. I had previously purchased knob from other vendor which wound up not fitting. This fit perfectly Read more