Frigidaire Dryer Screws, Nuts, Washers

Push-on nut for compactors. Secures mechanical components and fasteners. Replace if worn, stripped, missing, or when disassembling for repairs.

Single replacement screw for securing trim, panels, or brackets in your dryer. Needed when original hardware is missing, stripped, or damaged during repairs.

Replacement truss head screw for countertop microwaves. Secures internal components and panels. Order when original screw is stripped, missing, or lost.

A replacement mounting screw used to secure components on compatible Frigidaire appliances. This genuine-style fastener restores proper fit where the original screw is missing, stripped, or damaged for safe operation. What it does:

• Secures trim, panels, brackets, or components to prevent rattling and misalignment
• Restores a proper mechanical connection when the original screw is lost or worn
• Helps eliminate vibration noise caused by loose fasteners
• Compatible with specific Frigidaire assemblies that use this style of screw

• Screw only

• Use the correct screw location and size—do not force or overtighten to avoid stripping threads or cracking plastic parts
• Turn off power or disconnect appliance from power source before accessing internal components
• Wear safety glasses and handle small parts carefully to avoid injury or loss

This is a replacement mounting screw used on select appliances to secure panels and components; the almond-colored head matches factory appearance and helps maintain a finished look. Ideal when original screws are stripped, missing, or damaged. What it does:

• Fastens appliance panels, trim, and brackets where an 18 x 1.250 in screw is required
• Replaces lost or damaged screws that cause loose or rattling panels
• Restores correct fit and appearance when original head color is faded or worn
• Helps prevent parts from shifting during normal use

• One almond-head screw (18 x 1.250 in), exact quantity as shown

• Use the matching screwdriver or driver bit to avoid stripping the head
• Hand-start the screw before using a driver; do not over-torque
• Disconnect power to the appliance and move or support panels as needed for safe access

This is a painted 1/4-20 machine screw used to secure appliance panels and components, restoring proper fit and stopping movement. It replaces small hardware lost or worn during repairs. What it does:

• Fastens panels, brackets, or assemblies with a 1/4-20 threaded hole
• Helps stop rattling, vibration, or loose-fitting parts
• Restores secure mounting after service or part replacement
• Matches finish to keep visible areas looking consistent

• Disconnect power and move the appliance to a safe, stable work area before servicing
• Use the matching screwdriver or socket; install by hand first to avoid cross-threading
• Tighten until snug—do not overtighten to prevent stripped threads or damaged parts
• Replace with the same size and finish screw; inspect threads before forcing