Frigidaire Microwave Parts

Replacement mounting screw that secures panels, trim, and internal components in microwaves and wall ovens. Needed when screws are stripped, missing, or lost.

This rectifier assembly (diode) is part of the microwave's high-voltage circuit, converting alternating current to direct current to power the magnetron. It works in conjunction with the high-voltage capacitor to double the transformer's output voltage. Replace this part if the microwave runs but does not heat, or if testing reveals the diode has shorted or opened.

Fix unresponsive controls or erratic operation with this microwave main control board. Restores normal panel response and system functions when the board fails.

Fix a microwave that won't stop running, has a dead display, or won't heat. This main control board restores programming and operation. Moderate DIY repair.

Fix a microwave that won't heat, turn, or run when you press start. This control board controls all functions and cycles. Moderate difficulty repair.

If your microwave isn't heating food or heats unevenly, the magnetron may have failed. This high-voltage tube generates microwave energy for cooking.

This motor capacitor helps start and run appliance electric motors by providing the brief boost of power the motor needs to reach operating speed. Replaces a failed capacitor to restore normal motor starting and performance. What it does:

• Provides the electrical phase shift and momentary voltage boost motors need to start and run
• Commonly replaced when a motor hums, will not start, or runs weakly
• Helps stabilize motor operation and reduce hard starting stresses
• Resolves intermittent or failed motor startup symptoms when capacitor is the root cause

• Disconnect power to the appliance before accessing or replacing the capacitor
• Discharge stored voltage in the capacitor before handling to avoid shock
• Verify terminal connections and orientation match the original before installation

Microwave won't turn on, made popping noise, or smells like burned electrical? The noise filter often fails when solder joints arc or short out.

Microwave won't heat but runs normally? This thermal fuse protects against overheating by cutting power when temperatures spike. Simple DIY fix.

This thermostat is the refrigerator temperature control that senses cabinet temperature and cycles cooling to help maintain set temperatures. It replaces a failed control to restore reliable temperature regulation. What it does:

• Senses refrigerator temperature and opens/closes the cooling circuit to maintain the set temperature
• Stops continuous compressor run when the cabinet reaches the set point
• Can cause warm or fluctuating temperatures, or a compressor that won't cycle when faulty
• Works with the control knob/selector to adjust interior temperature

• One thermostat

• Disconnect power before attempting service to avoid shock or compressor damage
• Handle the sensing bulb/capillary gently; avoid kinks or sharp bends
• Installation usually requires access to the control housing inside the cabinet and basic hand tools

This is a black plastic lens and frame assembly that covers the interior lamp on a microwave oven. It protects the light bulb from grease and moisture while diffusing light inside the cooking cavity. Replace this lens if it is cracked, yellowed, melted, or missing, which can leave the bulb exposed to splatter and reduce interior illumination.

Replace your microwave's touch pad panel if it's cracked, worn, or unresponsive. This control panel installs on the front console for easy navigation.

Replacement screw fastener for microwaves. Secures panels, brackets, and trim pieces in place. Needed when original screws are stripped, lost, or missing.

Replace your microwave's touch pad when buttons are unresponsive, cracked, or worn. This membrane switch installs on the control panel housing.