Frigidaire Microwave Parts

This mesh grease filter captures grease and food particles from exhaust air in your over-the-range ventilation system, helping protect the blower and keep the area around your cooktop cleaner. Replace a bent or saturated filter to restore proper airflow. What it does:

• Traps grease and particulates from cooking exhaust
• Helps maintain airflow through the venting system
• Common signs of replacement: torn/warped mesh, broken tabs, heavy grease saturation, or the filter falling out

• 1 mesh grease filter

• Disconnect power before servicing and let surfaces cool
• Wear gloves; filter edges can be sharp
• Access the filter from the bottom, release the latch or tabs, slide out the old filter, and seat the new one securely in the same orientation
• Do not operate the appliance without the grease filter installed

Control transformer that supplies the low-voltage power needed for the appliance's electronic control/console, restoring reliable operation when the original transformer fails or the display and controls lose power. What it does:

• Converts incoming line voltage to the low-voltage supply used by the control board and console.
• Keeps the display, touchpad/keys and control electronics powered and stable.
• Common symptoms of a failing transformer: unlit or blank display, unresponsive controls, intermittent operation, or control board power loss.
• Replace a visibly burned, cracked, or shorted transformer to prevent further electrical damage.

• Always disconnect power to the appliance before servicing to avoid electric shock.
• Take care with wiring: match original connector positions and secure all wire nuts/terminals.
• Inspect mounting hardware and insulation; replace any damaged fasteners or wires.

This replacement transformer supplies low-voltage power to the appliance control circuits, restoring reliable operation of the control board and related electronics. Installs in the refrigerator control assembly to replace a failed or noisy transformer. What it does:

• Converts line voltage to the low-voltage supply used by the control board and relays
• Helps stop control board errors, intermittent cooling, or loss of electronic functions when the transformer fails
• Works with the existing wiring harness and mounting points when matching the OEM part

• Disconnect power to the appliance before starting any repair to prevent shock or injury
• Match connectors and mounting orientation to the original part; retain any screws or clips
• Handle with care to avoid damaging windings or terminals; do not attempt to open or repair the transformer

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary