Frigidaire Washer Support Parts

• Shakes and moves
• Noisy

I watched the video posted by Jerrod Sessler on yellow van handyman.com. Then I had to unstack the dryer from the washer, remove all covers, disconnect all hose connections, shock mounts and springs and remove the tub assembly. Then I disassembled the tub assembly and remove seal and both bearings from the rear half. At this point I cleaned everything. I installed new bearings and seal, installed the basket and assembled both tub halves using a new gasket and silicone, and reinstalled the... Read more

Replaced pump. All components are accessible from the front of the machine. You have to remove two screws in the back that hold on the top cover, then slide the cover back. This will allow access to the screws that hold on the control panel. Remove the control panel (unplug cable), then remove the spring/wire that holds on the door bellows to the front panel (removing and installing that is the most difficult part of the job) and carefully remove the bellows from the front panel. Then remove... Read more

I tore it apart using. YouTube videos to guide me and found the shocks were loose and floppy. I found the shocks in stock here and had them in my hand 2 days later for only $10 shipping! It runs great now! Read more

My less than 2-year-old Frigidaire washing machine started to spin violently on the final spin. Thanks to appliance parts pro I was able to find the diagrams and parts easily. I ordered the parts I needed and they arrived quickly in a couple of days. I was able to repair the machine for about half the price in probably would have been if I had a repair service do the work. Read more

My less than 2-year-old Frigidaire washing machine started to spin violently on the final spin. Thanks to appliance parts pro I was able to find the diagrams and parts easily. I ordered the parts I needed and they arrived quickly in a couple of days. I was able to repair the machine for about half the price in probably would have been if I had a repair service do the work. Read more

The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more

Well even thou the error code was 59 in the initial diagnosis, the problem was not actually the motor or the gaskets somehow a piece o laundry was flushed in between the washing drum an it`s casing, so basically this piece of cloth got stuck where heating element is install and there`s a little clip(the part that I order) that is just holding the element, now this clip just broke and with the piece o cloth stuck in there the machine started making this loud noise, we thought it was the end of... Read more