General Electric Range Hood Parts

Is your range hood not venting properly or making excessive noise? This blower assembly restores proper ventilation. Mounts with bolts—no need to remove hood.

This capacitor is an electrical component used in the control or fan motor circuit of a range or oven. It stores and releases electrical energy to help start or run motors and stabilize voltage in electronic control boards. Replace this capacitor if the convection fan or ventilation motor fails to start, runs intermittently, or if the control board is malfunctioning.

Fix unresponsive buttons or a non-functioning control panel with this range hood control board. Restores full electronic operation and settings.

Fix a hood fan that only works on high speed or requires manual spinning to start. This control board regulates fan speed settings and motor operation.

Secures wiring harnesses in your range. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number before ordering.

Damper assembly installs in your range hood duct system to control airflow. Replace if damaged, cracked, or missing to restore proper ventilation.

Replace a cracked, broken, or missing range hood damper. Installs in the exhaust duct system to prevent backdraft when the hood is not in use.

Replace your hood blower wheel if your range hood runs but has weak airflow or makes excessive noise. Restores proper ventilation and quiet operation.

If your range hood isn't venting properly or making unusual noises, a worn blower wheel may be the cause. This part restores proper airflow in minutes.

Lower duct cover panel for range hood ventilation systems. Replaces cracked, dented, or missing covers. Installs on the lower ductwork section.

Lower duct cover for range hoods. Conceals ductwork beneath the hood unit. Replace if cracked, discolored, or missing to restore finished appearance.

This is an upper duct extension designed for range hood vent systems. It extends the ductwork to accommodate higher ceilings or longer venting distances, ensuring proper airflow from the hood to the exterior exhaust point. Replace this part if the existing duct extension is damaged, dented, or if you need additional length to complete a proper vent installation.

Bottom duct cover for range hood ventilation systems. Replaces cracked, damaged, or missing duct covers on the underside of your hood assembly.

Upper duct cover for range hood ventilation systems. Replaces cracked, damaged, or missing covers that expose ductwork. Installs over the vent duct.