General Electric Range Hood Parts

This is a 8-18 x 1-1/4 machine screw used to secure appliance panels and components. It replaces a stripped, missing, or loose screw to restore stable attachment and safe operation. What it does:

• Fastens panels, brackets, or components where a #8-18 x 1-1/4 machine screw is specified
• Stops rattling or vibration caused by loose or missing fasteners
• Replaces stripped or worn screws that no longer hold securely
• Used in many appliance assemblies that require a standard #8-18 threaded fastener

• One (1) screw, 8-18 x 1-1/4

• Use the correct driver (Phillips or slotted as applicable) and size to avoid stripping the head
• Tighten until snug; avoid over-tightening which can strip threads or damage parts
• Disconnect power to the appliance before accessing internal components or panels

Secures your range hood to the wall or cabinet. Replace if the original screw or bushing is missing, stripped, or broken during installation or removal.

This is a replacement mounting screw used to fasten appliance panels and components, restoring secure fit and reducing rattles or loose parts. It's a direct-fit threaded fastener commonly used in household ranges and ovens. What it does

• Secures panels, brackets, or small components to the appliance frame
• Prevents parts from shifting, vibrating, or producing noise during operation
• Restores proper alignment when a worn or missing screw causes loose-fitting parts
• Works where a short machine or sheet-metal screw is required for repair

• Use the matching screw hole and thread; do not force or cross-thread
• Hand-start threads, then tighten with the appropriate screwdriver until snug
• If replacing a stripped thread, assess need for a nut, clip, or thread repair before tightening
• Disconnect power and follow appliance safety procedures when working near electrical components

This is a replacement latch stud screw used to secure a door latch or latch stud assembly. It restores proper latch retention so the door closes and stays aligned for normal operation. What it does:

• Secures the latch stud or latch mounting point to the appliance frame
• Keeps the latch firmly in place to prevent a loose or rattling door
• Helps restore proper door alignment and reliable latching
• Common symptom: door won't latch, latch feels loose, or parts shift when closing

• Disconnect power to the appliance before starting any repair
• Use the correct-size screwdriver to avoid stripping the head
• Thread the screw in carefully and tighten until snug; avoid overtightening
• Check latch alignment and operation after installation

Installation hardware kit for range hoods. Includes mounting brackets, screws, and fasteners needed to securely install your hood. Replace missing or damaged pieces.

This small plastic wire clip secures an appliance wiring harness to the cabinet or chassis, keeping wiring routed and held firmly to prevent rubbing or pinching during use. What it does:

• Holds wiring harnesses in place to reduce movement and protect insulation
• Prevents wires from contacting hot or sharp surfaces that can cause wear
• Reduces rattling or banging noises from loose wiring
• Helps prevent intermittent electrical connections caused by loose or strained wires

• One wire clip

• Disconnect power to the appliance before starting any work
• Clip typically snaps into a pre-punched hole or slides onto a flange; line up the harness and press clip until it seats
• Inspect wiring and insulation when replacing clip; route wires away from heat and moving parts
• Replace with the exact part number for a proper fit