General Electric Range Hood Screws, Nuts, Washers

Replacement mounting nut for range hood installation. Secures hood components and mounting brackets. Order a new nut if yours is stripped, missing, or damaged.

Hardware bag for range hoods includes screws, nuts, and washers needed for installation or repair. Replace if hardware is missing, stripped, or lost.

Mounting screw for electric wall ovens, gas ranges, and refrigerators. Replaces lost, stripped, or damaged screws used to secure panels and components.

Includes 12 screws.

Hex keps nut for compactor or hood assembly. Replaces missing, stripped, or corroded fasteners. Secures internal components during installation.

This is a #8-18 x 0.25-inch screw used to secure panels, trim, and small components on appliances. It replaces lost or damaged mounting screws to restore a secure fit and stop rattling or loose parts. What it does:

• Fastens sheet metal panels, brackets, and trim pieces
• Replaces stripped, missing, or damaged screws that cause loose panels or rattling
• Restores proper alignment for doors, control panels, and access covers
• Works where a short #8-18 machine/sheet-metal screw is required

• One #8-18 x 0.25" screw

• Use the correct screwdriver or bit to avoid stripping the head
• Do not overtighten; snug until secure to prevent thread damage or panel distortion
• Keep track of small parts during disassembly; consider using a magnetic tray
• Disconnect power and follow appliance safety instructions when accessing internal components

Hardware bag with screws, nuts, and washers for range hood installation and assembly. Replace lost or missing mounting hardware for secure installation.

This is a 8-18 x 1-1/4 machine screw used to secure appliance panels and components. It replaces a stripped, missing, or loose screw to restore stable attachment and safe operation. What it does:

• Fastens panels, brackets, or components where a #8-18 x 1-1/4 machine screw is specified
• Stops rattling or vibration caused by loose or missing fasteners
• Replaces stripped or worn screws that no longer hold securely
• Used in many appliance assemblies that require a standard #8-18 threaded fastener

• One (1) screw, 8-18 x 1-1/4

• Use the correct driver (Phillips or slotted as applicable) and size to avoid stripping the head
• Tighten until snug; avoid over-tightening which can strip threads or damage parts
• Disconnect power to the appliance before accessing internal components or panels