This surface burner valve switch mounts on the gas valve stem and signals the spark module when you turn the knob. Replacing a faulty switch restores consistent clicking and reliable ignition on the affected cooktop burner. What it does:
- Mounts to the surface burner gas valve and closes the ignition circuit when the knob is turned to Lite
- Sends power to the spark module to create the clicking needed to ignite the flame
- Symptoms may include: burner won't spark, intermittent ignition, continuous clicking with knobs off, or a burner lights only when another knob is turned
What's included:
Install notes:
- Disconnect electrical power and shut off gas supply; allow the cooktop/range to cool
- Remove the knob and front panel or manifold cover to access the valve area
- Note wire positions, transfer the wires to the new switch, and secure it on the valve stem in the same orientation
- Reassemble, restore power and gas, then test burner ignition
Do-It-Yourself Stories from Customers like You
Clicking from ignitor mode would not stop after burner lit Jeffrey Maclachlan V. • Nederland , CO • September 03, 2017
Turned out the little switches on the knob shaft had corroded and were staying on. There was constant continuity showing with an ohm meter. Replacing the switches was very easy (always disconnect power to the unit before servicing). Bought a new ignitor module as a backup as they do go out of production after 10 years or so- another cheap and easy fix if needed in the future.
Read more