General Electric Range Tube Or Fitting

Delivers gas to your range's right front burner. Replace if cracked, bent, or leaking. Installs between valve and burner with wrench. Quick DIY fix.

Replaces cracked, bent, or broken left front burner tube on gas ranges. Delivers gas from valve to burner head. Common wear part needing replacement.

Carries gas from the pressure regulator to the burner valve manifold on your gas range. Replace if the tube is damaged, cracked, or leaking to restore safe fuel flow.

Delivers gas from the manifold to your range's surface burner. Replace this tube if it's cracked, leaking, corroded, or damaged to restore safe gas flow.

This tube routes water from the refrigerator's water valve to the dispenser or ice system, restoring proper water flow and stopping leaks when a cracked or clogged supply tube is the issue. Easy direct replacement for affected lines. What it does

• Carries water from the valve to the dispenser or ice maker so the appliance can fill and dispense properly.
• Commonly replaced when you see leaks at fittings, a puddle under the fridge, or a visibly cracked or split tube.
• Can restore normal water flow when the line is pinched, kinked, or partially obstructed.
• Works with factory fittings and clamps used on the valve-to-ice maker/dispenser connection.

• Turn off the refrigerator's water supply and unplug the appliance before starting; drain remaining water from the line.
• Inspect fittings for damage; loosen or remove existing clamps/fittings to swap the tube, then secure new tube and clamps to prevent leaks.
• After installation, restore water and power, check all connections for leaks, and run the dispenser/ice maker briefly to confirm proper flow.

Gas supply tube for ranges. Connects the gas valve to burners. Replace if tube is kinked, cracked, or disconnected. Restores proper gas flow to cooktop.

Burner tube for the right rear position on your range cooktop. Replace if cracked, corroded, or damaged to restore proper gas flow to the burner head.

Pre-formed gas line that connects the inlet regulator to the burner manifold in gas ranges. Replace if damaged, cracked, or leaking to restore safe operation.

Replace the left front burner tube on your range. Needed when the tube is cracked, corroded, or damaged, preventing proper gas flow to the burner head.

Burner tube assembly for gas ranges. Connects burner to gas supply valve. Replace if cracked, damaged, or leaking to restore safe operation.

This 7/16 replacement tube routes water inside the refrigerator to the ice maker or dispenser, restoring proper water flow and preventing leaks. It's a direct-fit replacement when the original tube is cracked, split, or clogged. What it does

• Carries water from the valve to the ice maker or dispenser line
• Replaces damaged, cracked, or kinked tubing that causes leaks
• Restores proper water flow when the dispenser or ice maker is starved or slow
• Helps stop visible water pooling or dripping inside the refrigerator

• One 7/16 replacement tube

• Turn off water supply and unplug the appliance before starting any work
• Confirm routing and secure connections match the original tube to avoid kinks
• Use proper fittings and a firm push or clamp connection; replace any damaged clips or seals

Routes gas from the manifold to the right-rear cooktop burner. Replace if cracked, damaged, or leaking to restore proper gas flow and ignition.