General Electric Range Nameplate, Faceplate

This logo badge is the decorative nameplate used on select cooking appliances. Replacing a missing or worn emblem restores the finished factory look and keeps the front of your appliance looking complete and consistent with the original design.

• Cosmetic component that displays the appliance logo and completes the front panel or door
• Replaces a badge that is missing, cracked, peeling, or discolored
• Helps refresh the appliance's appearance without affecting operation
• Common signs: badge fell off, won't adhere, looks faded or damaged

• Disconnect power before working near control panels or doors
• Note the badge's original location and orientation before removal
• Use a non-marring tool to gently lift the old emblem if present; avoid scratching finishes
• Clean and dry the surface thoroughly before pressing the new badge into place

This center trim is the molded bezel that fits the front center of the cooktop/oven control area, restoring a finished look and protecting the control panel edges from heat and grime. What it does:

• Covers and protects the exposed edge of the control panel for a clean appearance
• Hides gaps, chips or discolored trim that make the console look worn
• Helps prevent dirt and grease from getting behind the control assembly
• Restores proper alignment and fit where the original trim is cracked or broken

• Disconnect power to the appliance before starting any repair.
• Typically secures with clips or screws—retain hardware and note orientation when removing old trim.
• Handle edges carefully; replacement may require gentle prying with a trim tool.
• If mounting hardware or support brackets are damaged, replace them separately.

This replacement faceplate covers and protects the SCR/control area on compatible GE cooking appliances, restoring a finished appearance while keeping control components secure. It's a direct-fit exterior trim piece for service and cosmetic repair. What it does:

• Covers and secures the SCR/control assembly to prevent exposure of components
• Helps keep grease, food debris, and accidental contact away from control parts
• Restores proper fit and appearance when the original faceplate is cracked, bent, or missing
• Can eliminate rattle or movement caused by a loose or damaged faceplate

• Disconnect power to the appliance before starting any service
• Use appropriate tools and keep hardware organized for reassembly
• Handle carefully to avoid scratching the finish or bending mounting tabs
• Inspect surrounding seals and wiring; replace or reposition as needed during reassembly