Parts for Kenmore 795.75042610 (79575042610, 795 75042610): Ice Maker Parts

Removes impurities and contaminants from water and ice. Replace every 6 months or 200 gallons for clean, fresh-tasting water. Verify fit by model.

Ice maker not making ice or constantly leaking? This ice maker assembly kit restores ice production. DIY-friendly installation takes under an hour.

Ice won't dispense but ice maker works? The auger motor drives ice from the bin to the chute. Moderately easy repair with our video guide and DIY tips.

This holder assembly is a structural mounting piece that supports and secures an internal component in your appliance. Replacing a cracked or worn bracket helps restore proper alignment and keeps parts stable during everyday use.

• Provides a rigid mounting point for the attached component
• Keeps parts aligned to reduce movement and vibration
• Helps prevent rattling or noise from loose mounts
• Common signs of failure: visible cracks/broken tabs, looseness, or parts that won't stay seated

• Disconnect power and, if applicable, turn off the water supply before service
• Note the orientation of the original part to match fitment
• Reuse existing mounting screws or hardware unless the manufacturer specifies otherwise
• Do not overtighten fasteners; the secured component is fully seated and stable

Ice bin cracked, warped, or causing weak dispensing and jams? This ice bucket assembly stores and delivers ice to your dispenser. Easy DIY repair.

The ice maker and auger motor assembly powers the mechanisms that produce ice and push it from the storage bin through the dispenser chute. Without a functioning motor, the ice maker will stop producing ice and the auger will no longer move ice to the dispenser. Replace this assembly if your ice maker has stopped making ice, the dispenser is not dispensing ice, or you hear a humming or grinding noise from the ice bin area.

Molded door shelf cover for the home bar compartment. Replaces cracked, broken, or missing covers. Installs on the refrigerator door for a finished look.

Replacement door hinge assembly for your refrigerator. Installs on the cabinet to support the door. Replace if cracked, bent, or worn for proper alignment.

Secures and supports refrigerator door pivot for proper alignment and smooth operation. Replace when door sags, seals poorly, or binds. Confirm fit with model.

This is a rubber seal gasket that fits around the ice or water dispenser door on the refrigerator. It creates an airtight seal to prevent cold air from escaping and warm air from entering the ice bank area. Replace this gasket if you notice frost buildup around the dispenser, ice clumping in the dispenser chute, or if the seal appears cracked, torn, or no longer sits flush.

Replaces a cracked, broken, or missing ice dispenser door handle on your refrigerator. Installs on the exterior dispenser for easy ice access.

Roller component for the ice dispenser door handle on bottom-mount refrigerators. Replaces broken, worn, or missing rollers. Ensures smooth handle operation.

Seals the ice bank door to prevent warm air from melting ice and causing clumping. Replace if ice melts, refreezes into clumps, or frost forms around the bin.